Whirlpool 1VET27DKGW1 Panduan Penggunaan & Perawatan - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Kulkas Whirlpool 1VET27DKGW1. Whirlpool 1VET27DKGW1 27 halaman. Top-mount refrigerator
Halaman Cetak
I
NSTALLING YOUR
REFRIGERATOR
It is important to prepare your refrigerator for use. This
section tells you how to clean it, install it, connect it to a
power source, and level it.
Unpacking your
refrigerator
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Removing packaging materials
•
Remove tape and any labels from your refrigerator
before using (except the model and serial number label/
plate).
To remove any remaining tape or glue, rub the area
briskly with your thumb. Tape or glue residue can also
be easily removed by rubbing a small amount of liquid
dish soap over the adhesive with your fingers. Wipe
with warm water and dry.
•
Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape
or glue. These products can damage the surface of
your refrigerator. For more information, see "Important
Safety Instructions" in the "Refrigerator Safety" section.
IMPORTANT:
•
Do not remove any permanent instruction labels inside
your refrigerator, or the Tech Sheet that is attached to
the refrigerator behind the base grille.
Cleaning before use
After you remove all of the packaging materials, clean the
inside of your refrigerator before using it. See the
cleaning instructions in the "Caring for Your Refrigerator"
section for more information.
Space requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion,
or fire.
•
To ensure proper ventilation for your refrigerator, allow
for a 1" (2.5 cm) space at the top and back and 1/2"
(1.25 cm) on each side of the refrigerator.
1" (2.5 cm) minimum at top and back
1/2" (1.25 cm) minimum at each side
•
If your refrigerator has an ice maker, make sure you
leave some extra space at the back to allow for the
water line connections. The refrigerator can be flush
against the back wall if you do not have an ice maker
installed.
•
If you are installing your refrigerator next to a fixed wall,
leave 2-1/8" (5.4 cm) minimum of space between the
hinge side of door and wall. This space is needed to
allow door to swing open.
NOTE: Do not install the refrigerator near an oven,
radiator, or other heat source, nor in a location where the
temperature can fall below 55°F (13°C).
5