Whirlpool 3ED25DQ Panduan Penggunaan dan Perawatan - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Kulkas Whirlpool 3ED25DQ. Whirlpool 3ED25DQ 24 halaman. No-frost refrigerator-freezers with thirst crusher
Juga untuk Whirlpool 3ED25DQ: Panduan Penggunaan dan Perawatan (30 halaman), Panduan Penggunaan dan Perawatan (30 halaman)

Halaman Cetak
Solving
common
ice maker
problems
_ -_ -. -.-.--
- -- --.-
PROBLEM
CAUSE
SOLUTIONS
-_-_---.-_._
_ --. _- - -_----.-
----
Ice dispenser
l
Freezer door open
* Close the freezer door.
won't work
l
Ice bin not properly installed
9 Make sure bin is pushed In all the way.
l
Wrong ice in bin
* Use only crescents
from ice maker. Shake
the bin occasionally
to keep cubes separated
and to obtain increased storage capacity.
l
Dispenser not used for
* Dump old ice and make a new supply.
extended periods, causing
ice cubes to melt together
..__ --__-.--
_-.-.-.-._---_-----._--
Ice dispenser
l
Ice dispenser bar held in
* Wait about 3 minutes for the dispenser motor
stops working
too long
to reset.
a Large amounts of ice should be taken from the
bin, not through
the dispenser.
.---_--.-
--.--.-~-----
Off-taste
or
odor in ice
l
Ice attracts airborne odors;
l
old ice
l
Water quality
1
l
Foods not properly wrapped
l
. Ice bin and freezer may
*
need cleaning
l
Plumbing to ice maker
.
l
New ice maker
.
Dump old ice and make a new supply. Store
excess ice in covered container.
Water containing minerals (such as sulfur) may
require a filter to remove.
Wrap properly. See pages 20 and 21.
Clean freezer and ice bin. See cleaning chart
on page 18.
Follow Installation Instructions for proper ice
maker water supply hook up. (See back of
refrigerator cabinet.)
The first few loads of ice from a new ice maker
may have an off-taste. Dump ice and make a
new supply.
Removing
the door
trim
$dispewxa
zwea)
(3ED27DQ
and 6ED27DQ
only)
To remove the trim:
1. Remove all items from the shelf.
2. Pull trim piece straight up at each end.
To replace the trim:
1. Locate each end of trim piece above the trim
pocket opening in refrigerator door liner.
2. Push the trim piece straight down until it stops.
3. Replace items on the shelf.