Whirlpool 3VET16GKGW01 Panduan Penggunaan & Perawatan - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Kulkas Whirlpool 3VET16GKGW01. Whirlpool 3VET16GKGW01 39 halaman. Top-mount refrigerator

Halaman Cetak

INSTALLING YOUR

REFRIGERATOR

Unpacking Your Refrigerator

WARNING

Excessive Weight Hazard

Use two or more people to move and install

refrigerator.

Failure to do so can result in back or other injury.

Removing Packaging Materials

Remove tape and any labels from your refrigerator

before using (except the model and serial number

label).

To remove any remaining tape or glue, rub the area

briskly with your thumb. Tape or glue residue can also

be easily removed by rubbing a small amount of liquid

dish soap over the adhesive with your fingers. Wipe

with warm water and dry.

Do not use sharp instruments, rubbing alcohol,

flammable fluids, or abrasive cleaners to remove tape

or glue. These products can damage the surface of

your refrigerator. For more information, see

"Refrigerator Safety" section.

On some models, shelves, bins, door shelf rails, and

other feature parts may be packaged in the Finishing

Touches™ FeaturePak. Follow the instructions

contained in the package for proper assembly.

IMPORTANT:

Depending on your model, do not remove any

permanent instruction labels inside your refrigerator, or

the Tech Sheet that is fastened behind the base grille.

Depending on your model, do not remove the white

Styrofoam insert that is located behind the control

panel on the ceiling of the refrigerator. The insert is part

of the refrigerator and not part of the packing material.

If the insert is removed, ice may migrate down from the

freezer and cause icicles to form.

Space Requirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as

gasoline, away from refrigerator.

Failure to do so can result in death, explosion,

or fire.

To ensure proper ventilation for your refrigerator, allow

for a .5" (1.25 cm) space on each side

Allow 3" (7.5 cm) of space between overhead cabinets

and refrigerator top.

Allow at least 1" (2.5 cm) between back of cabinet and

the wall.

3" (7.5 cm)

If your refrigerator has an ice maker, make sure you

leave some extra space at the back for the water line

connections.

If you are installing your refrigerator next to a fixed wall,

leave 2" (5 cm) minimum on the hinge side (depending

on your model) to allow for the door to swing open.

Level the refrigerator (See "Door Closing and

Alignment").

NOTE: Do not install the refrigerator near an oven, radiator,

or other heat source, nor in a location where the

temperature will fall below 40° F (5° C).

2" (5.08 cm)