Ariston ASL800CX Buklet Instruksi - Halaman 2

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Pengering Ariston ASL800CX. Ariston ASL800CX 44 halaman.

Important Information

For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below:

Fluff Filter...

! You MUST clean the fluff filter after EVERY drying

cycle.

STEP 1.

Open the door of your

dryer.

! Failure to clean the filter after EVERY drying cycle will affect the drying performance of your machine.

It will take longer to dry and as a result will use more electricity during drying.

Water Container...

! You MUST empty the water container after EVERY

drying cycle.

STEP 1.

Pull the water container

towards you and remove

it fully from the dryer.

! Failure to empty the water container will result in:

The machine will stop heating (so the load may still be wet at the end of the drying cycle).

The 'Empty Water' light will flash to tell you that the water container is full.

Priming the Water Collection System

When your dryer is new, the water container will not collect water until the system is primed... this will take 1 or 2 drying

cycles. Once primed it will collect water during every drying cycle.

STEP 2.

Pull out the filter (using

the two finger grips).

STEP 2.

Empty all the water

collected in the water

container.

STEP 3.

Clean any fluff deposits

from the filter mesh.

STEP 3.

Refit the water container,

ensuring that it is pushed

fully back into position.

STEP 4.

Refit the filter - NEVER

run the dryer without the

filter in position.

! The 'Empty Water' light

stays on - To remind you to

empty the water container

at the start and at the

end of each programme.