Ariston TCF 97B Manual - Halaman 15

Jelajahi secara online atau unduh pdf Manual untuk Pengering Ariston TCF 97B. Ariston TCF 97B 16 halaman.

Halaman Cetak

Troubleshooting

One day your dryer seems not to be working. Before you call your Service Centre (see Service), go through the following

troubleshooting suggestions:

Problem:

The tumble dryer won't start.

Drying cycle will not begin.

Its taking a long time to dry.

The 'water container full'icon

is flashing and "H20" displayed

but the dryer has only been running

for a short period.

Empty water icon

is on and

the water container is not full.

Programme finishes and clothes are

damper than expected.

The display shows a fault code F

followed by one or two numbers.

Possible causes / Solution:

• The plug is not plugged into the socket, or not making contact.

• There has been a power failure.

• The fuse has blown. Try to plug another appliance into the socket.

• You are using an extension cord? Try to plug the dryer's power cord directly into the

socket.

• The door is not closed securely?

• The programme has not been set properly (see Start and Programmes).

• The Start/Pause button has not been pressed (see Start and Programmes).

• You have set a delayed time (see Start and Programmes).

• The filter has not been cleaned (see Maintenance).

The water container needs emptying... The 'water container full' icon

is flashing, the display shows "H20" and the 'empty water' icon

(see Maintenance).

• The condenser needs cleaning? (see Maintenance).

• The temperature setting is not ideal for the type of fabric you are drying (see Start

and Programmes, and see Laundry).

• The correct drying time has not been selected for the load (see Laundry).

• The air intake grille is obstructed (see Installation, and see Maintenance).

• The items were too wet (see Laundry).

• The dryer was overloaded (see Laundry).

• The water container was probably not emptied at the start of the programme. Do not

wait for the empty water signal, always check and empty the container before starting

a new drying programme (see Maintenance).

• This is normal. If the icon is on it is just a reminder to empty the container (see Start

and Programmes).

! For safety the dryer has a maximum programme time of 5 hours. If an automatic

programme has not sensed the required final moisture in this time the dryer will com-

plete the programme and stop. Check the above points and run the programme again,

if the results are still damp, contact the Service Centre (see Service).

• If the display shows a fault:

- Turn off and remove the plug. Clean the filter and the condenser (see mainte-

nance). Then replace the plug, turn on and start another programme. If a fault is then

displayed: Note down the code and contact the Service Centre (see Service).

is on