Ariston TVM63X NA Informasi Layanan - Halaman 5
Jelajahi secara online atau unduh pdf Informasi Layanan untuk Pengering Ariston TVM63X NA. Ariston TVM63X NA 19 halaman. Electro-mechanical vented tumble dryers
Halaman Cetak
Indesit
Company
MACHINE FUNCTION
Cold air is drawn into the dryer cabinet interior through
louvres in the cabinet base, passes through the large hole in
the inner back panel adjacent to the fan and is driven through
the element housing on the inner back panel.
After passing through the element windings and through
holes in the drum back plate into the drum interior, the now
warm air is driven through the load to the front of the drum.
A webbing seal, fixed to the inside of the inner back panel,
prevents warm air being driven into the cabinet interior.
As the drum revolves, the load is tumbled through the warm
air stream, that extracts moisture from the damp fabric.
The now moist and cooled air passes through the filter in the
air duct on the back of the front panel, where any fluff picked
up from the load is removed.
The air then travels through the front to rear air duct, leaving
the dryer at the rear outlet.
If required, a vent hose may be attached to the outlet, to take
exhaust air away from the dryer.
A cut-out on the element housing, cuts the electricity Live supply to the element, if the air temperature
in the housing becomes too high due to a restriction in the air flow, e.g a blocked filter. The cut-out
automatically resets when the air temperature drops to an acceptable level and cycles if the fault
persists.
A second 'one shot' cut-out, mounted alongside the 'auto reset' cut-out, is fitted as a safety device to
break the element Neutral connection, if the air temperature reaches an unsafe level due to failure of
the 'auto reset' cut-out.
There are two thermostats in the front air duct when only one is in use at any one time depending on
which programme is selected. These sense the exhaust temperature rise when the load becomes dry
and energise the timer motor on the main timer. This allows it to advance to cool run.
AUTOMATIC DRYING
To work correctly High Heat has to be enabled and between 3 Kg to 6 Kg of Cottons dried. If smaller or
delicate loads are dried using the automatic setting, erratic results will be achieved.
Automatic Drying Explanation
NOTE: - The heat switch must be set to the high position otherwise there will be no circuit to the timer
motor or heater when the exhaust thermostat signals that the clothes are dry.
continued on next page.....
Service Manual UK
AIRFLOW DIAGRAM
5 of 19
English