Whirlpool 27' Panduan Petunjuk Instalasi - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool 27'. Whirlpool 27' 27 halaman. Microwave oven and thermal oven
Juga untuk Whirlpool 27': Bantuan Pekerjaan (36 halaman), Panduan Petunjuk Instalasi (11 halaman), Panduan Petunjuk Instalasi (11 halaman), Panduan Petunjuk Instalasi (48 halaman), Panduan Petunjuk Instalasi (22 halaman), Panduan Petunjuk Instalasi (32 halaman), Panduan Petunjuk Instalasi (12 halaman), Petunjuk Instalasi (5 halaman)

Halaman Cetak

Whirlpool 27' Panduan Petunjuk Instalasi

Special provisions for mobile home installations:

The exhaust vent must be securely fastened to a noncombustible

portion of the mobile home structure and must not terminate

beneath the mobile home. Terminate the exhaust vent outside.

Determine vent path:

Select route that will provide straightest and most direct

path outdoors.

Plan installation to use fewest number of elbows and turns.

When using elbows or making turns, allow as much room

as possible.

Bend vent gradually to avoid kinking.

Use as few 90° turns as possible.

Determine vent length and elbows needed for best

drying performance:

Use following "Vent System Chart" to determine type of vent

material and hood combinations acceptable to use.

NOTE: Do not use vent runs longer than those specified

in "Vent System Chart." Exhaust systems longer than those

specified will:

Shorten life of dryer.

Reduce performance, resulting in longer drying times

and increased energy usage.

The "Vent System Chart" provides venting requirements that

will help achieve best drying performance.

Vent System Chart

Number of

Type

90° turns

of vent

or elbows

Rigid metal

NOTE: Side exhaust installations have a 90º turn inside the

dryer. To determine maximum exhaust length, add one 90º

turn to the chart.

Box/louvered

Angled

hoods

35 ft. (10.7 m)

37 ft. (11.3 m)

32 ft. (9.7 m)

27 ft. (8.2 m)

24 ft. (7.3 m)

19 ft. (5.8 m)

Install Vent System

Install exhaust hood

Install exhaust hood and use caulking compound to seal

exterior wall opening around exhaust hood.

Connect vent to exhaust hood

Vent must fit over the exhaust hood. Secure vent to exhaust

hood with 4" (102 mm) clamp. Run vent to dryer location using

straightest path possible. Avoid 90° turns. Use clamps to seal

all joints. Do not use duct tape, screws, or other fastening

devices that extend into interior of vent to secure vent,

because they can catch lint.

12" min.

(305 mm)

12" min.

(305 mm)