Whirlpool 4KAED4900 Panduan Penggunaan dan Perawatan - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Pengering Whirlpool 4KAED4900. Whirlpool 4KAED4900 36 halaman.

Halaman Cetak

TROUBLESHOOTING

if you experience

Clothes are not drying

satisfactorily,

drying

times are too long

First try the solutions suggested here to possibly avoid the cost of a service call.

Possible

Causes

Lint screen clogged with lint.

Has the Air Dry cycle been

selected.

Load too large and heavy to dry

quickly.

Exhaust vent or outside exhaust

hood clogged with lint, restricting air

movement.

Fabric softener sheets blocking

the grill.

Exhaust vent not the correct length.

Exhaust vent diameter not the

correct size.

Dryer located in a room with

temperature

below 7°C (45°F).

Dryer located in a closet without

adequate opening.

Solution

Lint screen should be cleaned before each load.

Select the right cycle for the types of garments being dried.

See "Cycle Guide."

Separate the load to tumble freely.

Run the dryer for 5-10 minutes. Hold your hand under the

outside exhaust hood to check air movement.

If you do not feel

air movement,

clean exhaust system of lint or replace exhaust

vent with heavy metal or flexible metal vent. Make sure vent is

not crushed or kinked. See Installation Instructions.

Use only one fabric softener sheet, and use it only once.

Check that the exhaust vent is not too long or has too many

turns. Long venting will increase drying times. Make sure vent

is not crushed or kinked. See Installation Instructions.

Use 102 mm (4") diameter vent material.

Proper operation of dryer cycles requires temperatures

above

7°C (45°F).

Closet doors must have ventilation openings at the top and

bottom of the door. The front of the dryer requires a minimum

of 25 mm (1 ") of airspace, and, for most installations, the rear of

the dryer requires 127 mm (5"). See Installation Instructions.

Dryer will not run

Door not closed completely.

Make sure the dryer door is closed completely.

PUSH TO START/End of Cycle

Press and hold the PUSH TO START/End of Cycle Signal knob

Signal knob not pressed firmly or

until you hear the dryer drum moving.

held long enough.

Household fuse is blown or circuit

Electric dryers use 2 household fuses or circuit breakers. The

breaker has tripped,

drum may be turning, but you may not have heat. Replace both

fuses or reset the circuit breaker. If the problem continues, call

an electrician.

Incorrect power supply.

Electric dryers require 220-240-volt

power supply.

Check with a qualified electrician.

Wrong type of fuse.

Use a time-delay fuse.

Unusual sounds

Dryer had a period of non-use.

If the dryer hasn't been used for awhile, there may be a

thumping sound during the first few minutes of operation.

Is a coin, button, or paper clip

Check the front and rear edges of the drum for small objects.

caught between the drum and front

Clean out pockets before laundering.

or rear of the dryer?

Is it a gas dryer?

The gas valve clicking is a normal operating sound.

Are the four legs installed, and is the

The dryer may vibrate if not properly installed.

dryer level front to back and side to

See Installation Instructions.

side?

Clothing knotted or balled up.

When balled up, the load will bounce, causing the dryer to

vibrate. Separate the load items and restart the dryer.

No heat

Household fuse is blown or circuit

The drum may be turning, but you may not have heat. Electric