Whirlpool 7MWGD1930 Panduan Petunjuk Instalasi - Halaman 42
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool 7MWGD1930. Whirlpool 7MWGD1930 44 halaman. Electric/gas dryer
Juga untuk Whirlpool 7MWGD1930: Panduan Penggunaan dan Perawatan (32 halaman)
Halaman Cetak
Complete Installation
Checklist
Ɨ
Check that all parts are now installed. If there is an extra part,
go back through steps to see what was skipped.
Ɨ
Check that you have all of your tools.
Ɨ
Dispose of/recycle all packaging materials.
Ɨ
Check dryer's final location. Be sure vent is not crushed
or kinked.
Ɨ
For power supply cord installation, plug into an outlet.
For direct wire installation, turn on power.
Ɨ
Check that dryer is level. See "Level Dryer".
Ɨ
Remove film on console and any tape remaining on dryer.
Ɨ
Wipe dryer drum interior thoroughly with a damp cloth to
remove any dust.
Ɨ
Read "Dryer Use" in your "Use and Care Guide".
Ɨ
Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
For Electric Dryers:
If the dryer will not start, check the following:
■ Controls are set in a running or "On" position.
■ Start button has been pushed firmly.
■ Dryer is plugged into an outlet and/or electrical supply is
on.
■ Household fuse is intact and tight, or circuit breaker has
not tripped.
■ Dryer door is closed.
Ɨ
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close the door.
If you do not feel heat, turn off dryer, and check the
following:
■ There may be 2 household fuses or circuit breakers for the
dryer. Check that both fuses are intact and tight, or that
both circuit breakers have not tripped. If there is still no
heat, contact a qualified technician.
NOTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used. The
odor will go away.
42
For Gas Dryers:
If the dryer will not start, check the following:
■ Dryer is plugged into a grounded 3-prong outlet.
■ Electrical supply is connected.
■ Household fuse is intact and tight, or circuit breaker has
not tripped.
■ Dryer door is closed.
Ɨ
When the dryer has been running for 5 minutes, open the
dryer door and feel for heat. If you feel heat, cancel cycle and
close the door.
If you do not feel heat, turn the dryer off and check to see
whether gas supply line shut-off valve is open.
■ If the gas supply line shut-off valve is closed, open it, then
repeat the 5-minute test as outlined above.
■ If the gas supply line shut-off valve is open, contact a
qualified technician.
NOTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used. The
odor will go away.