Whirlpool 8577208 Panduan Petunjuk Instalasi - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool 8577208. Whirlpool 8577208 36 halaman. Commercial dryer – gas or electric

Halaman Cetak

Direct Wire Method – U.S. Only

WARNING

Use 10 gauge solid copper wire.

Use a UL listed strain relief.

Disconnect power before making electrical connections.

Connect neutral wire (white or center wire) to center

terminal (silver).

Ground wire (green or bare wire) must be connected to

green ground connector.

Connect remaining 2 supply wires to remaining

2 terminals (gold).

Securely tighten all electrical connections.

Failure to do so can result in death, fire, or

electrical shock.

Direct wire cable must match power supply (4-wire or 3-wire)

and be:

■ Flexible armored cable or nonmetallic sheathed copper cable

(with ground wire), protected with flexible metallic conduit. All

current-carrying wires must be insulated.

■ 10-gauge solid copper wire (do not use aluminum).

■ At least 5 ft. (1.52 m) long.

Direct Wire,

Four-wire electrical connection:

1" (2.5 cm)

of wires

stripped of

disconnect

insulation

box

5" (12.7 cm)

Strip 5" (12.7 cm) of outer covering

from end of cable. Leave green or bare

Shape ends

ground wire at 5" (12.7 cm). Cut 1 "

of wires into

(3.8 cm) from 3 remaining wires. Strip

a hook.

insulation back 1" (2.5 cm).

" conduit connector

B. Neutral (white or center)

C. Ground wire (green or bare)

D. 10-gauge, 3 wire with ground wire in

Fire Hazard

5. Remove the center terminal block screw.

6. Remove the appliance neutral ground

7. Connect the ground wire (green or bare)

8. Place the hooked end of the neutral wire

9. Place the hooked ends of the other

10. Insert tab of the terminal block cover into

1. Disconnect power.

2. Remove hold-down screw and terminal block cover.

3. Install

block opening. Connect flexible metallic conduit and tighten

connector screw. Install direct wire cable through the flexible

metallic conduit.

4. Complete installation following instructions for your type of

electrical connection:

• Four-wire (recommended method)

• Three-wire (if four-wire is not available)

wire from the external ground conductor

screw. Fasten under center, silver-

colored terminal block screw.

of the direct wire cable to the external

ground conductor screw. Tighten screw.

(white or center) of the direct wire cable

under the center screw of the terminal

block (hook facing right). Squeeze hook

end together. Tighten screw.

direct wire cable wires under the outer

terminal block screws (hook facing right).

Squeeze hooked ends together. Tighten

screws.

slot of the dryer rear panel. Secure cover

with hold-down screw.

A. External ground conductor screw

B. Tab

C. Terminal block cover

D. Hold-down screw

" conduit connector into the hole below the terminal

A. Conduit connector

B. Dryer cabinet

C. Connector screw

A. External ground conductor screw

B. Appliance neutral ground wire

C. Center terminal block screw

D. Outer terminal block screws

E. Neutral (center wire)

F. Green or bare ground wire