Whirlpool AED4475TQ1 Petunjuk Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Pengering Whirlpool AED4475TQ1. Whirlpool AED4475TQ1 24 halaman.

Halaman Cetak

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

Dryer will not run

Has a household fuse blown, or has a circuit breaker tripped?

■

Electric dryers use 2 household fuses or circuit breakers. The

drum may be turning, but you may not have heat. Replace the

fuse or reset the circuit breaker. If the problem continues, call

an electrician.

Is the correct power supply available?

■

Electric dryers require 240-volt power supply. Check with a

qualified electrician.

Was a regular fused used?

■

Use a time-delay fuse.

Is the dryer door firmly closed?

■

Was the Start button or knob firmly pressed?

■

Is a cycle selected?

■

The dryer will not start in the Wrinkle Prevent position. Move

the dial past OFF.

No heat

Has a household fuse blown, or has a circuit breaker tripped?

■

Electric dryers use 2 household fuses or circuit breakers. The

drum may be turning, but you may not have heat. Replace the

fuse or reset the circuit breaker. If the problem continues, call

an electrician.

For gas dryers, is the valve open on the supply line?

■

Unusual sounds

Has the dryer had a period of non-use?

■

If the dryer hasn't been used for awhile, there may be a

thumping sound during the first few minutes of operation.

Is coin, button, or paper clip caught between the drum and

■

front or rear of the dryer?

Check the front and rear edges of the drum for small objects.

Clean out pockets before laundering.

Is it a gas dryer?

■

The gas valve clicking is a normal operating sound.

Are the four legs installed, and is the dryer level front to back

■

and side to side?

The dryer may vibrate if not properly installed. See the

Installation Instructions.

Is the clothing knotted or balled up?

■

When balled up, the load will bounce, causing the dryer to

vibrate. Separate the load items and restart

the dryer.

Timer does not noticeably advance

Is the dryer set to Timed or Air Dry?

■

The timer moves slowly and continuously for the timed setting.

Is the dryer set to Automatic Drying?

■

The timer moves only when the clothing is mostly dry.

TROUBLESHOOTING

to possibly avoid the cost of a service call...

In U.S.A. http://www.whirlpool.com/help - In Canada www.whirlpool.ca

Clothes are not drying satisfactorily or drying times are

too long

Is the lint screen clogged with lint?

■

Lint screen should be cleaned before each load.

WARNING

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death

or re.

Is the exhaust vent or outside exhaust hood clogged with lint,

■

restricting air movement?

Run the dryer for 5-10 minutes. Hold your hand under the

outside exhaust hood to check air movement. If you do not feel

air movement, clean exhaust system

of lint or replace exhaust vent with heavy metal or flexible

metal vent. See the Installation Instructions.

Are fabric softener sheets blocking the grille?

■

Use only one fabric softener sheet, and use it only once.

Is the exhaust vent the correct length?

■

Check that the exhaust vent is not too long or has too many

turns. Long venting will increase drying times. See the

Installation Instructions.

Is the exhaust vent diameter the correct size?

■

Use 4" (102 mm) diameter vent material.

Is the dryer located in a room with temperature below

■

45ºF (7ºC)?

Proper operation of dryer cycles requires temperatures

above 45ºF (7ºC).

Fire Hazard