Whirlpool AWZ8377 Panduan Referensi Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Referensi Cepat untuk Pengering Whirlpool AWZ8377. Whirlpool AWZ8377 9 halaman.
Halaman Cetak
SAFETY ADVICES BEFORE USING THE DRYER /
CONNECTIONS
1. Removing the packaging and check
• After unpacking, make sure that the dryer is
undamaged. If in doubt, do not use the dryer.
Contact After-Sales Service or your local retailer.
• Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, as
they are potentially dangerous.
If the appliance was exposed to the cold prior to
delivery, keep it at room temperature for a few
hours before operating.
2. Electrical Connections
• Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer's instructions and current standard
safety regulations.
• Electrical connection must comply with local
Electricity Board regulations.
• Voltage information, power consumption and the
required fuse protection is shown on the rating
plate mounted at the rear of the dryer.
• The manufacturer cannot accept any liability for
personal injury or damage to property resulting
from failure to adhere to these instructions.
• The dryer must be earthed as prescribed by law.
• Do not use extension leads or multiple adaptors.
• Do not use electrical portable outlet devices.
• Before any maintenance on the dryer disconnect it
from the mains supply.
• Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales
Service technicians.
• Mains cable replacement is only to be carried out by
After-Sales Service.
• After installation access to the mains plug has to be
guaranteed, or the all-pole disconnection has to be
possible with a switch.
3. Installation
• Do not install your dryer where it can be subject to
extreme conditions, such as: poor ventilation,
temperatures below 5°C or above 35°C.
• The appliance must not be installed behind a
lockable door, a sliding door or a door with a hinge
on the opposite side to that of the tumble dryer, in
such a way that a full opening of the tumble dryer
door is restricted.
• Take care not to install the dryer on a deep-pile carpet.
• Take care not to trap the mains cable between the
dryer and the wall.
• The exhaust air must not be discharged into a flue
which is used for exhausting fumes from appliances
burning gas or other fuels.
• Pay attention that the air-inlet openings are
unobstructed.
Stability:
When installing the dryer always carefully level the
dryer adjusting the two feet and check the correct
levelling with a spirit level.
4
To built in the dryer
• For security reasons do not remove the worktop.
• Connect the dryer to an external ventilation system
in order to prevent steam from damaging your
furniture during the years.
Stacking kit
Your dryer can be stacked on top of your front
loading washing machine. Please contact your
dealer or our After Sales Service.
Minimum housing dimensions:
Width:
600 mm
Height:
855 mm
Depth:
560 mm