Whirlpool CABRIO WGD8600YW0 Panduan Penggunaan dan Perawatan - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Pengering Whirlpool CABRIO WGD8600YW0. Whirlpool CABRIO WGD8600YW0 36 halaman. Gas dryer
Juga untuk Whirlpool CABRIO WGD8600YW0: Panduan Petunjuk Instalasi (36 halaman)
Halaman Cetak
DITIONAL
FEATURES
USING THE DRYING
RACK
To obtain a drying rack for your dryer, follow the instructions
included in your dryer drum. Remove and discard any
packing materiN before use.
Use the Drying Rack for items that you do not want to
tumble dry, such as sweaters and tennis shoes. When you
use the drying rack, the drum continues to turn, but the rack
remains stationary.
The drying rack is intended for use with the Timed Dry
Cycles only. The drying rack cannot be used with any
Automatic Cycles.
To use the drying
rack:
IMPORTANT:
Do not remove the lint screen.
1. Open dryer door.
I
2. Align the two hooks on the front of the drying rack with
the holes in the dryer door opening and press down fully
into holes. Rest the rear support on the dryer back ledge.
3. Place wet items on top of the drying rack. Allow space
around items for air to circulate. The drying rack does
not move, but the drum will rotate; be sure to leave
adequate clearance between items and the inside
of the dryer drum. Make sure items do not hang over
the edges or between drying rack grille.
4. Close the door.
5. Select Timed Dry. Select the Air Only, Low or Extra Low
Temp setting. Items containing foam, rubber, or plastic
must be dried on a clothesline or by using the Air Only
Temp setting.
6. When the cycle is selected, the Estimated Time
Remaining display shows the default time. You can
change the actual time in the cycle by increasing or
decreasing the cycle time.
7. Press START/PAUSE.
NOTE: Check the lint screen and remove any lint
accumulated
from items dried on the drying rack
after the cycle is finished.
Electrical
Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
r
CHANGING
THE DRUM
LIGHT
The dryer light automatically turns on inside the dryer drum
when you open the door.
To change
the drum
light:
1. Unplug dryer or disconnect
power.
2. Open the dryer door. Locate the light bulb cover on the
back wall of the dryer. Remove the screw located in the
lower right corner of the cover. Remove the cover.
3. Turn bulb counterclockwise.
Replace the bulb with
a lO-watt appliance bulb only. Replace the cover and
secure with the screw.
4. Plug in dryer or reconnect power.
10