Whirlpool CGW9100VQ0 Panduan Instalasi - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengering Whirlpool CGW9100VQ0. Whirlpool CGW9100VQ0 40 halaman. Commercial dryer- gas or electric

Halaman Cetak

Direct wire,

3=wire

connection:

Use where local codes permit connecting

cabinet=

ground conductor

to neutral wire.

Direct wire cable must have 5 ft (1.52 m) of extra length so

dryer can be moved if needed.

Strip 37/2"(8.9 cm) of outer

t?., _ c_

covering from end of cable. Strip

insulation back 1" (2.5 cm). If

using 3-wire cable with ground

wire, cut bare wire even with outer

covering. Shape ends of wires into

_s,_ c_

a hook shape.

When connecting to the terminal block, place the

hooked end of the wire under the screw of the

1_1

terminal block (hook facing right), squeeze hooked

end together, and tighten screw, as shown.

1. Loosen or remove center silver-colored terminal

block screw.

2. Place the hooked end of the neutral wire (white

or center wire) of direct wire cable under the

center screw of terminal block (hook facing

right). Squeeze hooked end together. Tighten screw.

3. Place the hooked ends of the other direct

wire cable wires under the outer terminal

block screws (hooks facing right). Squeeze

hooked ends together. Tighten screws.

4. Tighten strain relief screw.

5. Insert tab of terminal block cover into slot

of dryer rear panel. Secure cover with

holddown screw.

6. You have completed your electrical connection.

Now go

to "Venting Requirements."

...... ¢

..........................

",i: ,;

..............................

_/j::::

:::_J

.................................................

A. External ground conductor screw

B. Neutral ground wire

C. Center silver-colored terminal block screw

D. Neutral wire (white or center wire)

E. 3/4"(1.9 cm) UL listed strain relief

Optional,

3-wire connection:

Use for direct wire or power supply cord

where local codes do not permit

connecting

cabinet=ground

conductor

to neutral wire.

1. Remove center silver-colored terminal

block screw.

2. Remove neutral ground wire from

external ground conductor screw.

Connect neutral ground wire and the

neutral wire (white or center wire) of

power supply cord/cable under center,

silver-colored terminal block screw.

Tighten screw.

3. Connect the other wires to outer terminal

block screws. Tighten screws.

4. Tighten strain relief screws.

5. Connect a separate copper ground wire

from the external ground conductor

screw to an adequate ground.

6. Insert tab of terminal block cover into

slot of dryer rear panel. Secure cover

with holddown screw.

B. Center silver-colored terminal block screw

C. Neutral ground wire

D. Neutral wire (white or center wire)

E. 3/4"(1.9 cm) UL listed strain relief

F. Grounding path determined by a qualified

electrician