Whirlpool CSP2760TQ2 Panduan Petunjuk Instalasi - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool CSP2760TQ2. Whirlpool CSP2760TQ2 36 halaman. Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)

Halaman Cetak

REVERSINGTHE DOORSWING(OPTIONAL)

You can change your door swing from a right-side opening to a

left-side opening, if desired.

Open dryer door. Remove bottom screws from cabinet side of

hinges (A). Loosen (do not remove) top screws from cabinet

side of hinges.

Lift door until top screws in cabinet are in large part of

hinge slot. Pull door forward off screws. Remove top

screws from cabinet.

Remove screws attaching hinges to door.

Remove screws from all sidess of door (5 screws). Grasp

sides of outer door and gently lift to separate it from inner

door (do not pry apart). Do not pull on door seat or plastic

door catch.

Reattach outer door panel to

inner door panel so handle

is on the side where hinges

were just removed.

Attach door hinges to dryer door so that the larger hole is

at the bottom of the hinge and the hinge pin is toward the

door front.

7. Remove the 4 screws that attach 2 plugs (B) on the handle

side. Attach plugs to opposite side using the same 4 screws.

8. Insert screws into bottom holes on left

side of cabinet. Tighten screws halfway.

Position door so large end of door hinge

slot is over screws. Slide door up so

screws are in bottom of slots. Tighten

screws. Insert and tighten top

screws in hinges.

9. Close door and check that door strike aligns with door

catch (C).

MAINTENANCE INSTRUCTIONS

Maintenance

instructions:

[] Clean lint screen after each cycle.

[] Removing accumulated

lint:

• From inside the dryer cabinet:

Lint should be removed every 2 years or more often,

depending on dryer usage. Cleaning should be done

by a qualified person.

• From the exhaust vent:

Lint should be removed every 2 years, or more often,

depending on dryer usage.

[] Keep area around dryer clear and free from combustible

materials, gasoline and other flammable vapors and liquids.

[] Keep dryer area clear and free from items that would obstruct

the flow of combustion and ventilation air.

If dryer does not operate,

check the following:

[] Electrical supply is connected.

[] Circuit breaker is not tripped or house fuse is not blown.

[] Door is closed.

[] Controls are set in a running or "ON" position.

[] Cycle has been selected.

[] For gas dryers, check that gas supply shutoff valves are set

in open position.

If you need assistance:

The Commercial Laundry Support Center will answer any

questions about operating or maintaining your dryer not covered

in the Installation Instructions. Just dial 1-800 NO BELTS

(1-800-662-3587)

-- the call is toll free.

When you call, you will need the dryer model number and serial

number. Both numbers can be found on the serial-rating plate

located in the dryer door well.