Whirlpool CSP2760TQ3 Panduan Petunjuk Instalasi - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool CSP2760TQ3. Whirlpool CSP2760TQ3 36 halaman. Commercial stacked dryer gas (120-volt,60-hz)or electric (120/240-volt,60-hz)

Halaman Cetak

Direct Wire

Method

- U.S. Only

Fire Hazard

Use 10 gauge solid copper wire.

Use a UL listed strain relief.

Disconnect power before making electrical

connections.

Connect neutral wire (white or center wire) to center

terminal

(silver).

Ground wire (green or bare wire) must be connected to

green ground connector.

Connect remaining 2 supply wires to remaining

2 terminals

(gold).

Securely tighten all electrical connections.

Failure to do so can result in death, fire, or

electrical

shock.

Direct wire cable must match power supply (4-wire or 3-wire)

and be:

[]

Flexible armored cable or nonmetallic sheathed copper cable

(with ground wire), protected with flexible metallic conduit.

All current-carrying

wires must be insulated.

[]

10-gauge solid copper wire (do not use aluminum).

[]

At least 5 ft. (1.52 m) long.

1. Disconnect power.

Remove hold-down screw and terminal block cover.

A........

A. External ground conductor screw

B. Tab

C. Terminal block cover

D. Hold-down screw

Install ,_A"conduit connector into the hole below the terminal

block opening. Connect flexible metallic conduit and tighten

connector screw. Install direct wire cable through the flexible

metallic conduit.

A. Conduit connector

B. Dryer cabinet

C. Connector screw

Complete installation following instructions for your type of

electrical connection:

Four-wire (recommended method)

Three-wire (if four-wire is not available)

Direct Wire,

Four=wire electrical

connection:

5" (127 mm)

Strip 5" (127 mm) of outer covering

from end of cable. Leave green or bare

Shape ends

ground wire at 5" (127 mm). Cut I_A"

of wires into

(38 mm) from 3 remaining wires. Strip

a hook.

insulation back 1" (25 mm).

A. s/4" ( 19mm) conduitconnector

B. Neutral(whiteor center)

C. Groundwire (greenor bare)

D. lO-gauge,3 wirewith groundwire

in flexiblemetallicconduitO

5. Remove the center terminal block screw.

6. Remove the appliance neutral ground

wire from the external ground conductor

screw. Fasten under center, silver-

colored terminal block screw.

7. Connect the ground wire (green or bare)

of the direct wire cable to the external

ground conductor screw. Tighten screw.

8. Place the hooked end of the neutral wire

(white or center) of the direct wire cable

under the center screw of the terminal

block (hook facing right). Squeeze hook

end together. Tighten screw.

9. Place the hooked ends of the other

direct wire cable wires under the outer

terminal block screws (hook facing right).

Squeeze hooked ends together. Tighten

screws.

10. Insert tab of the terminal block cover into

slot of the dryer rear panel. Secure cover

with hold-down screw.

E¸

A. External ground conductor screw

B. Appliance neutral ground wire

C. Center terminal block screw

D. Outer terminal block screws

E. Neutral (center wire)

F. Green or bare ground wire