Whirlpool Duet WED9150WW0 Panduan Petunjuk Instalasi - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool Duet WED9150WW0. Whirlpool Duet WED9150WW0 16 halaman. 27" electric dryer
Juga untuk Whirlpool Duet WED9150WW0: Panduan Penggunaan dan Perawatan (25 halaman)

Halaman Cetak

COMPLETE

INSTAL

ION

[]

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

[]

Check that you have all of your tools.

[]

Dispose of/recycle all packaging materials.

[]

Check dryer's final location. Be sure vent is not crushed

or kinked.

[]

Check that dryer is level. See "Level Dryer".

[]

Remove blue film on console and any tape remaining on

dryer.

[]

Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

[]

Read "Dryer Use" in your Use and Care Guide.

[]

For power supply cord installation, plug into a grounded

outlet. For direct wire installation, turn on Power.

[]

Select a Time Dry heated cycle, and start dryer. Do not select

Air Only Temperature setting.

If dryer will not start, check the following:

* Controls are set in a running or "On" position.

Start button has been pushed firmly.

Dryer is plugged into an outlet and/or electrical supply.

Household fuse is intact and tight, or circuit breaker has not

tripped.

Dryer door is closed.

This dryer automatically

runs an installation diagnostic routine

at the start of its first cycle.

NOTE: You may notice an odor when dryer is first heated. This

odor is common when heating element is first used. The odor

will go away.

DOOR

RE RS

If you prefer

to reverse

the door

swing

on your dryer:

[] A door reversal kit, Part Number W10277499 is available

to order. For further information, see "Assistance

or Service"

section in your Use and Care Guide, or to download

door reversal instructions

on your computer, have your model

number ready, and go to www.whirlpool.com.

Dryer

drum

turns,

but no heat:

[] Has a household fuse blown, or has a circuit breaker

tripped?

Electric dryers use 2 household fuses or circuit

breakers. Replace fuse or reset circuit breaker. If problem

persists, call an electrician.

Dryer

displaying

code

message:

On models with a time display:

[] "PF" (power failure) Check the following:

Was drying cycle

interrupted

by power failure? Press and hold START to restart

dryer.

Try the following:

Check if a household fuse has blown or circuit breaker has

tripped. Electric dryers use two household fuses or breakers.

Replace fuse or reset circuit breaker.

Confirm power cord is properly installed. Refer to "Electrical

Connection"

section for details.

Select a Timed Dry heated cycle, and restart dryer.

If message persists, consult a qualified electrician.

[] "F" Variable (F1E1, F2E2, F3E1, F3E2, FTE1, F3E6, F3ET}

service codes: Call for service.

On models without

a time display window:

[] "WET" indicator light is flashing

and all other display/

indicator lights on control

panel are off: Call for service.

Dryer Results

Clothes

are not drying

satisfactorily,

drying

times

are

too long,

or load

is too hot:

[] is lint screen clogged

with lint? Lint screen should be

cleaned before each load.

Fire Hazard

Use a heavy metal vent.

Do not use a plastic vent.

Do not use a metal foil vent.

Failure to follow these instructions can result in death

or fire.

TROUBLESHOOTING

Try these solutions

to possibly avoid costs of a service

calL.

Dryer

Operation

Dryer

will

not run:

[] Has a household

fuse blown, or has a circuit breaker

tripped?

Electric dryers use 2 household fuses or circuit

breakers. Check that both fuses are intact and tight, and

breakers have not tripped. Replace fuse or reset circuit

breaker. If problem persists, call an electrician.

[] is correct

power supply available?

Electric dryers require

240-volt power supply. Check with a qualified electrician.

[] Was a regular fuse used? Use a time-delay fuse.

[] is exhaust vent or outside exhaust hood clogged with lint,

restricting air movement?

Run dryer for 5-10 minutes. Hold

hand under outside exhaust hood to check air movement.

you do not feel air movement, clean exhaust system of lint or

replace exhaust vent with heavy metal or flexible metal vent.

[] Are fabric softener

sheets blocking

grille? Use only one

fabric softener sheet, and use each only once.

[] is exhaust vent correct

length? Check if exhaust vent is too

long or has too many turns. Long venting increases dry time.