Whirlpool Easy Clean 100 Series Panduan Penggunaan dan Perawatan - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Pengering Whirlpool Easy Clean 100 Series. Whirlpool Easy Clean 100 Series 27 halaman. Electric and
gas dryers
Juga untuk Whirlpool Easy Clean 100 Series: Panduan Penggunaan dan Perawatan (24 halaman)
Halaman Cetak
3. Turn the Cycle Control Knob to the
desired cycle. Use the Energy
Preferred Automatic Setting (*)
to dry most loads (see page 8).
4. Set the Temperature Selector to the
desired setting. Refer to drying
cycles charts on pages 1 O-l 2.
5. Push the Start Button.
NOTES:
l
Your dryer stops automatically when a
cycle ends.
l
Higher air flow from your new dryer may
blow out accumulated lint from the existing
exhaust system.
Stopping/restarting
your dryer
You can stop your dryer anytime during a cycle.
To stop the dryer, elther:
To restart the dryer:
l
Open the dryer door.
1.
Close the door.
2. Select a new cycle and temperature
(if desired).
3. Push the Start Button.
OR
l
Turn the Cycle Control Knob
to Off.
NOTE: The Cycle Control Knob
should point to an Off area
when the dryer is not in use.