Fireplace World Miami Curve Buku Petunjuk - Halaman 2
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Perapian Dalam Ruangan Fireplace World Miami Curve. Fireplace World Miami Curve 4 halaman. 42 inch wall mount electric fireplace
15)
Alaways plug heater directly into wall outet or
receptacle.Never use with extension cord or
retractable power bar(outlet power strip).
16)
Do not plug this product into a receptacle controlled by
a wall switch or dimmer.
17)
When storing or transporting the unit and cord,keep in a
dry place,free from excessive vibration and store so as
to avoid damage.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE.
CAUTION:
IF YOU USE THIS HEATER IN CONJUNCTION WITH A
THERMAL CONTROL,A PROGRAM CONTROLLER,A TIMER
OR ANY OTHER DEVICE THAT SWITHCHES THE HEATER
ON AUTOMATICALLY,REMEMBER TO OBSERVE ALL
SAFETY WARNINGS AT ALL TIMES. THE FIREPLACE
HEATER HAS SAFETY OVERHEAT PROTECTION. IF THE
OVERHEAT PROTECTION TRIPS,SWITCH OFF ALL
SWITCHES AND WAIT A PPROXIMATELY 5-10 MINUTES.
IT SHOULD RESET AUTOMATICALLY ONCE THE UNIT
COOLS DOWN.
WARNING:
PROCEDURES AND TECHNIQUES,IF NOT CAREFULLY
FOLLOWED,WILL RESULT IN DAMAGE TO THE
EQUIPMENT,AND WILL EXPOSE THE USER TO THE RISK
OF SERIOUS INJURY,ILLNESS OR DEATH.THIS ELECTRIC
FIREPLACE HEATER IS FOR USE ON 120 VOLTS.THE
CORD HAS A PLUG AS SHOWN AT A IN ILLUSTRATION
BELOW. AN ADAPTER AS SHOWN AT C IS AVAILABLE
FOR CONNECTING THREE-BLADE GROUNDING-TYPE
PLUGS TO TWO-SLOT RECEPTACLES. THE GREEN
GROUNDING LUG EXTENDING FROM THE ADAPTER
MUST BE CONNECTED TO A PERMANENT GROUND SUCH
AS A PROPERLY GROUNDED OUTLET BOX. THE
ADAPTER SHOULD NOT BE USED IF A THREE-SLOT
GROUNDED RECEPTACLE IS AVAILABLE.
A 15 AMP CIRCUIT IS REQUIRED TO OPERATE THIS HEATER.
IF THE BREAKER TRIPS WHEN THE HEATER IS USED,YOU
MAY NEED TO MOVE THE HEATER TO ANOTHER LOCATION
OR UNPLUG OTHER APPLIANCES THAT ARE ON THE SAME
CIRCUIT. IF YOU REQUIRE AN EXTENSION CORD,USE ONE
THAT IS RATED AT 1875 WATTS.
/
PARTS LIST
Fireplace.............................................................................1
A) Anchor screw.................................................................5
B) Wall anchors..................................................................5
C) Mounting bracket...........................................................1
TOOLS REQUIRED: LEVEL, ELECTRIC DRILL, DRILL BITS (8MM (5/16 IN
HEAD SCREWDRIVER,
HAMMER, SAFETY GOGGLES AND GLOVES
INSTALLATION
Please be aware: that no products should be sealed against
the wall/opening as this can effect the performance of the
heater unit.
Minimum Installation Height:
From floor level to bottom edge of product, Minimum 300mm.
This suite is supplied with a wall fixing Bracket.
The suite can be installed at any height as long as it is not
below the recommended 300mm. (Please note the 700mm
measurement is given as a common installation height).
The recommended installation height is a minimum of 300mm
from the floor level to the underside of the hearth.
2
)), PHILLIPS