Whirlpool WGD9750WW0 Panduan Penggunaan & Perawatan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Pengering Whirlpool WGD9750WW0. Whirlpool WGD9750WW0 29 halaman. Electronic dryer

Halaman Cetak

Moving care

For power supply cord-connected

dryers:

1. Unplug the power supply cord.

2. Steam models only: Shut off water faucet.

3. Steam models only: Disconnect the water inlet hose from

faucet, then drain the hose. Transport hose separately.

4. Make sure leveling legs are secure in dryer base.

5. Use masking tape to secure dryer door.

For direct-wired

dryers:

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical

shock.

1. Disconnect

power.

2. Disconnect wiring.

3. Steam models only: Shut off water faucet.

4. Steam models only: Disconnect the water inlet hose from

faucet, then drain the hose. Transport hose separately.

5. Make sure leveling legs are secure in dryer base.

6. Use masking tape to secure dryer door.

Reinstalling

the dryer

Follow the "Installation Instructions" to locate, level, and connect

the dryer.

Water Inlet Hoses

Replace inlet hoses and hose screen after 5 years of use to

reduce the risk of hose failure. Periodically inspect and replace

inlet hoses if bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, record the date of replacement.

To winterize

dryer

1. Unplug dryer or disconnect power.

2. Shut off water faucet.

3. Disconnect water inlet hose from faucet and drain.

To use dryer again

1. Flush water pipes. Reconnect water inlet hose to faucet. Turn

on water faucet.

2. Plug in dryer or reconnect power.

The dryer light automatically turns on inside the dryer drum when

you open the door.

To change the drum

light

1. Unplug dryer or disconnect power.

2. Open the dryer door. Locate the light bulb cover on the back

wall of the dryer. Remove the screw located in the lower right

corner of the cover. Remove the cover.

Turn bulb counterclockwise.

Replace the bulb with a 10-watt

appliance bulb only. Replace the cover and secure with the

screw.

4. Plug in dryer or reconnect power.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid the cost of a service call...

For additional recommendations,

refer to your Installation Instructions.

Dryer will not run

•

Is the dryer door firmly closed?

•

Was the Start button firmly pressed?

Large loads may require pressing and holding the Start button

for 2-5 seconds.

Has a household fuse blown, or has a circuit breaker

tripped?

There may be 2 household fuses or circuit breakers for the

dryer. Check that both fuses are intact and tight, or that both

circuit breakers have not tripped. Replace the fuse or reset the

circuit breaker. If the problem continues, call an electrician.

Is the correct power supply available?

Electric dryers require 240-volt power supply. Check with a

qualified electrician.

Was a regular fuse used?

Use a time-delay fuse.