Whirlpool WGD97HEXW0 Panduan Petunjuk Instalasi - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool WGD97HEXW0. Whirlpool WGD97HEXW0 38 halaman. Gas dryer
Juga untuk Whirlpool WGD97HEXW0: Panduan Penggunaan & Perawatan (36 halaman)
Halaman Cetak
INSTALLATION
REQUIREMENW$
TOOLS
AND
PARTS
Gather the required tools and parts before starting installation.
Tools
needed
for all installations:
Flat-blade screwdriver
#2 Phillips screwdriver
1/4" nut driver
Level
recommended)
Tape measure
Pliers
Utility knife
Tin snips (new vent
installations)
Caulking gun and compound
(new vent installations)
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Tools needed for gas installations:
8" or 10" pipe wrench
8" or 10" adjustable wrench
(for gas connections)
Pipe-joint compound
resistant to LP gas
Parts supplied:
Parts package is located in dryer drum. Check that all parts
are included.
NOTE: Do not use leveling legs supplied with dryer if installing
on a pedestal.
Leveling legs (4)
"Y" connector
Short inlet hose
Long inlet hose
Rubber washers
Min. 8" long Torx_> T25
screwdriver
(for door reversal only)
Parts needed:
(Not supplied with dryer)
[] Vent clamps
[] Vent elbows and ductwork
Additional parts may be required, depending
in your installation.
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements"
and "Venting Requirements"
before purchasing parts.
® TORXis a registered trademark of Acument Intellectual Properties, LLC.
4