Whirlpool WTW7500GC Panduan Penggunaan & Perawatan - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Pengering Whirlpool WTW7500GC. Whirlpool WTW7500GC 48 halaman. Electronic dryer
Juga untuk Whirlpool WTW7500GC: Panduan Petunjuk Instalasi (40 halaman), Panduan Penggunaan & Perawatan (32 halaman)
Halaman Cetak
Washer Maintenance
WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of
replacement on the label with a permanent marker.
NOTE: This washer does not include inlet hoses.
See the Installation Instructions for more information.
WASHER CARE
Recommendations to Help Keep Your Washer
Clean and Performing at Its Best
1. Always use High Efficiency (HE) detergents and follow
the HE detergent manufacturer's instructions regarding
the amount of HE detergent to use. Never use more than
the recommended amount because that may increase the
rate at which detergent and soil residue accumulate inside
your washer, which may result in undesirable odor.
2. Use warm and hot wash water settings sometimes
(not exclusively cold water washes), because they do
a better job of controlling the rate at which soils and
detergent accumulate.
3. Always leave the washer lid open between uses
to help dry out the washer and prevent the buildup
of odor-causing residue.
Cleaning Your Top-Loading Washer
Read these instructions completely before beginning
the routine cleaning processes recommended below.
This Washer Maintenance Procedure should be performed,
at a minimum, once per month or every 30 wash cycles,
whichever occurs sooner, to control the rate at which soils
and detergent may otherwise accumulate in your washer.
Cleaning the Inside of the Washer
To keep your washer odor-free, follow the usage instructions
provided above, and use this recommended monthly
cleaning procedure:
Clean Washer Cycle
This washer has a special cycle that uses higher water
volumes in combination with affresh
or liquid chlorine bleach to clean the inside of the washer.
Begin procedure
1. affresh
Washer Cleaner Cycle Procedure
®
(Recommended for Best Performance):
a. Open the washer lid and remove any clothing or items.
b. Place an affresh
Washer Cleaner tablet in the bottom
®
of the washer basket.
c. Do not place an affresh
in the detergent dispenser.
d. Do not add any detergent or other chemical to the
washer when following this procedure.
e. Close the washer lid.
f. Select the Clean Washer cycle.
g. Touch and hold the START/PAUSE button to begin
the cycle. The Clean Washer Cycle Operation is
described in the next column.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted, touch the POWER button. After the
Clean Washer cycle has stopped, run a Rinse & Spin cycle
to rinse cleaner from washer.
Washer Cleaner
®
Washer Cleaner tablet
®
WASHER CARE (cont.)
2. Chlorine Bleach Procedure (Alternative):
a. Open the washer lid and remove any clothing
or items.
b. Add 1 cup (236 mL) of liquid chlorine bleach
to the bleach compartment.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause washer damage
over time.
c. Close the washer lid.
d. Do not add any detergent or other chemical
to the washer when following this procedure.
e. Select the Clean Washer cycle.
f. Touch and hold the START/PAUSE button to begin
the cycle. The Clean Washer Cycle Operation is
described below.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted, touch the POWER button. After
the Clean Washer cycle has stopped, run a Rinse & Spin
cycle to rinse cleaner from washer.
Description of Clean Washer Cycle Operation:
1. This cycle will fill to a water level higher than in normal
wash cycles to provide rinsing at a level above the water
line for normal wash cycle.
2. During this cycle, there will be some agitation and
spinning to increase the removal of soils.
After this cycle is complete, leave the lid open to allow
for better ventilation and drying of the washer interior.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe away any spills.
Use only mild soaps or cleaners when cleaning external
washer surfaces.
IMPORTANT: To avoid damaging the washer's finish, do not
use abrasive products.
13