ABB CoriolisMaster FCH400 Series Panduan Konfigurasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Unit Kontrol ABB CoriolisMaster FCH400 Series. ABB CoriolisMaster FCH400 Series 11 halaman. Hspc module

Halaman Cetak
5.
Take note of the terminal connector point. This point is configured from the interface. The (J1-
1, J1-2) point is identified as DI1 in PCCU.
6.
Tighten connector screws to secure wires.
7.
Set module address if not using the default.
a. Insert the small flathead screwdriver in the address selector slot.
b. Rotate the address selector to the desired address. Ensure the address indicator points to
the desired address.
Figure 2-1: Wire terminals and set address
8.
If powering the HSPC module from an external power supply, go to section
module power (if
9.
If powering the HSPC module from the flow computer or controller, go to section
CoriolisMaster digital
3

Wire the HSPC module power (if required)

This procedure describes how to wire the HSPC to an external power supply. An external power supply
may be required depending on the number of points used and their configuration.
Prerequisites:
Tools: Small flathead screwdriver, fine tip marker
Determine the power mode for the HSPC module. This module can operate with backplane
power or external power depending on the number of channels used and their configuration.
Refer to
Table 3-1
external power is required.
Table 3-1: Recommended HSPC power mode per module configuration
I/O channel configuration
All channels are configured
as Pulse Inputs
All channels are configured
as Pulse Inputs or Digital Inputs
All channels are configured
as Digital Outputs
4 | HS PC CO N FI G U RATI ON G UI D E | 21 08 7 44M N A A
required).
output.
for general recommendations. Follow the steps of this procedure only if
Input configuration
(if applicable)
All inputs are configured with
Wetting Current/Pullup: Disabled
If any of the inputs is configured with
Wetting Current/Pullup: Enabled
Not Applicable
3 Wire the HSPC
4 Wire the
Power Mode
configuration
Use Backplane
Use External
Use External