Whirlpool YWED92HEFBD2 Panduan Petunjuk Instalasi - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pengering Whirlpool YWED92HEFBD2. Whirlpool YWED92HEFBD2 48 halaman.

DOOR REVERSAL (OPTIONAL)

The following instructions are for models with round and

square-shaped doors.

Tools needed:

Min. 8" (203 mm) long

TORX

T25

screwdriver

†

Reverse door swing: round-shaped door, fl at glass –

single handle

Remove door from dryer

IMPORTANT: If the protective fi lm has not yet been

removed from the dryer, peel the fi lm from the dryer

door before proceeding.

Using a T25

screwdriver, remove the four screws securing

the door hinge to the dryer and lift up and out to remove

the door. Place the door on a soft towel or other non-scratch

surface. Reinstall the four screws in the holes.

#2 Phillips screwdriver

Move the door strike

Using a T25

screwdriver, remove the two screws securing

the door strike to the door frame of the dryer. Rotate the strike

180° and attach to the opposite side of dryer door frame

as shown.

Remove inner door from outer door

Position the door with the inside of the door facing up.

Using a Phillips screwdriver, remove the 10 screws securing

the inner door to the outer door. Lift off the inner door and

set aside.

†

TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.