Calandra Racing Concepts Battle Axe 2.0 Panduan Perakitan - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Mobil Mainan Bermotor Calandra Racing Concepts Battle Axe 2.0. Calandra Racing Concepts Battle Axe 2.0 16 halaman. 1:10th oval weapon from team crc

Halaman Cetak

Side Shocks

CRC Dura-Shock Assembly Instructions

Bag 5

***Pre assembly inspection - Take the shock shaft and slide it through the black Delrin insert. Be sure the shaft slides through freely. If the shaft drags

on the Delrin, simply spin an X-acto Knife tip in each end of the delrin piece. The knife will remove the small manufacturing burr that occasionally forms

right near the end of the hole.

1 - Using the included 30 wt. silicone oil, soak the foam bladder in oil. Squeeze the foam to ensure the oil has soaked in. Wet the red O-ring as well.

2 - Populate the shock shaft in this order; plastic cup (open end away from piston), soaked foam, small washer + pre-oiled red O-ring.

3 - Hold the body upright and fill the body with oil to the line shown. Place the populated shaft in the oil slowly.

4 - Press the shaft slowly until it stops at the bottom of the shock. Slip the Delrin insert over the shaft and begin to thread into the shock body.

5 - The insert will stop threading, hydro-locking as the shock has too much oil. Oil will spill out.

6 - Allow the oil to bleed out, tightening and loosening the delrin insert while keeping the shaft fully depressed inside the body. This will bleed the

shock.

7 - When the shock is fully bled, no oil will leak and the shaft will rebound out very slowly when fully depressed. The shock shaft will rebound out 1/8".

8 - Be sure that the shock is fully bled, any "pressure" from being overfilled with oil will cause the shock to leak during the first few uses .

***Post assemble notes: Some oil may seep out of the shock near the Delrin insert. This is simply some remnants of the oil bleed process. Just wipe it

off after the first couple uses, and it should go away. This also may happen if the shock was built with too much oil in it. Be sure to bleed fully.

Oil Fill

Line

Durashock body

4284,85,86

1231

Ballcup

1 - Pop the completed side shocks on to the

ballstuds as shown, making sure that the

threaded spring adjusters face toward the outside

of the car.

13451 Foam

Housing Cup

4283 Durashaft

13458

threaded

insert

13451

washer

13451

o-ring

13451

Foam

1231

Ballcup

13456-rod

end, spring

perch

13783

4-40 x 1/8"

set screw

13459

spring preload

adjuster