Clarathon XL Panduan Pemilik - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Sistem Penyaringan Air Clarathon XL. Clarathon XL 4 halaman. Uv ozonator

Halaman Cetak

Specifications

Ozone Out-

Volume (USG)

put (gm/hr)

200 - 600

Location

Mount the Clarathon XL UV Ozonator underneath the spa skirt, in a location as high as possible. It may be necessary to

install the unit on the wall of the spa room or in a dry place under your deck. The unit should be mounted on a solid sur-

face with the provided screws in your parts package. Good air flow around the ozonator is important and it should be

mounted firmly. Mount the unit either horizontally -or- vertically with the end with the air-intake opening (corded end)

pointing downward to help prevent the possibility of water from entering the opening.

Important Note: Located on the end cap of the ozonator's power cord side are air intake holes to be left open to allow

air to pass through. We strongly suggest mounting your ozonator as high as possible (above the water level if practical)

and pull the clear ozone tubing into a double Hartford loop, which simply means to loop the ozone tubing up as high as

you can before you connect it to the ozonator. This helps to prevent water flooding, should the check valve ever fail.

Electrical

Many spa manufacturers make the electrical connection very easy by pre-wiring an outlet for your ozonator on or inside

the equipment pack (1). Ensure your Clarathon XL UV Ozone Generator voltage matches the voltage stated on the spa

pack or in the manual, for that outlet. The electrical service must be GFCI protected, as described earlier in this docu-

ment. Be sure to confirm that the ozonator's plug matches the receptacle and requirements of your control system.

Installing a spa ozone generator is not difficult. Most spa manufacturers sell their spas Ozone Ready from the factory.

This means your spa manufacturer has done most of the work for you. Even if your spa is not ozone ready, reading

through this instructional guide will simplify the installation. If you are replacing an existing ozonator, you can simply

connect to the existing ozone tubing, and the replacement should only take a few minutes!

Ozone-Ready Spas

Locate the end of the factory installed ozone-ready tubing (2) under the spa cabinet skirt. This clear tubing is usually

1/4" ID and may be capped off. Snip off the cap. Insert the 1/4" x 1/4" Check Valve into the supplied 1/4" tubing as

shown above, in the proper orientation. (Find the air-in and air-out ends by blowing through it). Ensure that air will

only flow one direction: toward the spa and away from the Clarathon ozonator.

Attach the other end of the check valve to the spa's ozone tubing as shown above. Check valve must be positioned

vertically, not horizontally, to prevent premature valve failure.

Attach the remaining end of the 1/4" ozone tubing to the barbed fitting on your Clarathon ozonator as shown in photo

(above right).

Air Draw

(scfh)

0.035

1 to 4

0.035

1 to 4

INSTALLATION

SPA INSTALLATION OPTIONS

Electrical Power

(volts/amps)

120V 0.3A, 240V

14"L x 2.75"D

120V 0.3A, 240V

14"L x 2.75"D

0.15A

Weight

Size

(lbs.)

Lamp Life

9000 Hours