AER acousti Cube 3 Panduan Petunjuk Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Penguat AER acousti Cube 3. AER acousti Cube 3 17 halaman.

Halaman Cetak

acoustiCube 3

That allows you to:

Switch between the two stored effects (memory 1, 2)

Switch on/ off the effect loops 1 + 2

Effect 1 (internal) on/ off: brief tapping

Effect 2 (external) on/ off: longer tapping

Connect volume pedals or footswitches to sockets ctr ch 1 and

ctr ch 2 to VCA level the volume of each channel or mute it

(e.g. in tuner mode) without affecting the sound.

When using a dual footwitch or a stereo volume pedal, a

single stereo connection with ctrl ch1 is sufficient.

effect 2

In addition, a further stereo effect unit, called

effect 2, can be connected. The send socket

needs to be connected to the input of the

effect unit.

The return socket is stereo, and accepts both output-channels

of the effect unit.

An "insert" -cable might be required (see "Wiring-Diagram").

The effect return and effect pan controls correspond to the

controls at the front (effect 1).

Please consider:

If you use a mono accessory unit, you would also use a mono

return-cable. The effect signal lies on the tip. The Acousticube

internally uses the left effect portion of effect 1 that also lies

on the tip.

Thus your mono accessory unit is linked with the acoustiCube,

but is only operative for the Acousticube. The signal is only

available at line (line out) and r–out when a special stereo-

cable is used. The mono-signal of the accessory unit should lie

exclusively on the "ring" (middle ring) of the stereo jack (the

effect only works on the right side, therefore not on the acou-

stiCube, only on the accessory box CX8). But if you connect

"tip" and "ring" the mono-effect will spread to both sides (left

and right), that is to the acoustiCube as well as to the stereo

extension CX8.

The ser/par-switch switches effect 2 from serial to parallel mo-

de, depending on whether the original signal is supposed to

pass through the effect completely (e.g. for EQ or compressor)

or whether it is separated.

-9-

Please note:

The signal path is interrupted in the serial mode. If no acces-

sory unit is connected, the signal cannot find its way into the

power amplifier, and you will hear nothing. This is not a mal-

function but a misuse.

When used in the serial mode,

the pan control should be set as follows: As far as it will turn

left:

effect on channel 1, not on channel 2

middle:

effect 2 on channel 1 and channel

As far as it will turn

right:

effect 2 on channel 2, not on channel 1.

That is it – have fun!

AER GmbH und Co. KG.

D – 45665 Recklinghausen

Telephone: +49 (0)23 61–89 17 89 / -90

www.aer-amps.com

Telefax: +49 (0)2361 – 891791

AER assumes no liability for printing mistakes. Technical data is

subject to alteration after printing.