Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan - Halaman 10

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan untuk Kap Ventilasi Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD. Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD 28 halaman. 30" and 36" (76.2 and 91.4 cm) wall-mount canopy range hood
Juga untuk Whirlpool 30" AND 36" (76.2 AND 91.4 CM) WALL-MOUNTCANOPY RANGE HOOD: Panduan Petunjuk Instalasi (28 halaman)

Halaman Cetak

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filters

before operating hood.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool

or soap-filled scouring pads.

Always wipe dry to avoid water marks.

Cleaning Method:

■

Liquid detergent soap and water or all-purpose cleanser

■

Wipe with damp soft cloth or nonabrasive sponge, and

then rinse with clean water and wipe dry.

Metal Grease Filter:

1. Remove the filter by pulling the spring release handle

and then pulling down the filter.

A. Spring release handle

2. Wash metal filters as needed in dishwasher or hot detergent

solution.

3. Reinstall the filter by making sure the spring release handles

are toward the front. Insert aluminum filter into upper track.

4. Push in spring release handle.

5. Push up on metal filter and release handle to latch into place.

Non-Vented (Recirculating) Installation Filters:

The charcoal filter is not washable. It should last up to 6 months

with normal use. Replace with Charcoal Filter Kit Number

W10412939.

To Replace Charcoal Filter:

1. Remove metal grease filter from range hood. See "Metal

Grease Filter" in this section.

2. Bend spring clips away from metal grease filter.

3. Place charcoal filter into top side of metal filter.

RANGE HOOD CARE

Cleaning

4. Bend spring clips back into place to secure the charcoal

5. Replace metal grease filter. See "Metal Grease Filter" in

Replacing a Lamp

Turn off the range hood and allow the lamp to cool. To avoid

damage or decreasing the life of the new bulb, do not touch

bulb with bare fingers. Replace bulb using tissue or wearing

cotton gloves to handle bulb.

If new lamps do not operate, make sure the lamps are inserted

correctly before calling service.

1. Disconnect power.

2. Use a Phillips screwdriver to remove screw from lamp cover.

3. Remove lamp cover and set lamp cover and the screw aside.

4. Remove bulb and replace with a new 120 volt, 40 watt

5. Replace lamp cover and reinstall screw.

6. Reconnect power.

filter to the metal filter.

this section.

maximum E-12 bulb.