Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan - Halaman 9

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan untuk Kap Ventilasi Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD. Whirlpool 30" WALL-MOUNT CANOPY RANGEHOOD 28 halaman. 30" (76.2 cm) wall-mount canopy range hood

Halaman Cetak

Make Electrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1. Disconnect power.

2. Remove terminal box cover.

3. Remove the knockout in the terminal box and install a UL

listed or CSA approved ¹⁄₂" strain relief.

4. Run home power supply wiring through ¹⁄₂" strain relief

into terminal box.

A. UL listed wire connectors

B. White wires

C. Black wires

D. Green (or bare) wire connected

to yellow-green wires

E. Home power supply

5. Use UL listed wire connectors and connect white wires

(B) together.

6. Use UL listed wire connectors and connect black wires

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire

in terminal box.

Failure to do so can result in death or electrical shock.

7. Connect green (or bare) ground wire from home power supply

to the 2 yellow-green ground wires (D) in terminal box using

UL listed wire connectors.

8. Tighten strain relief screw.

9. Install terminal box cover.

10. Reconnect power.

Install Vent Covers

1. When using both upper and lower vent covers, push lower

cover down onto hood and lift upper cover to ceiling and

install with (2) 2.9 x 6.5 mm screws.

NOTE: For vented installations, the upper vent cover may

be reversed to hide slots.

A. Upper vent cover

B. Lower vent cover

C. 2.9 x 6.5 mm screws

D. Bracket

Complete Installation

1. For non-vented (recirculating) installations only, install

charcoal filters over the grease filters, using the clips

provided in the kit. See the "Range Hood Care" section.

2. Install metal filters. See the "Range Hood Care" section.

3. Check the operation of the range hood blower and light.

See the "Range Hood Use" section.

NOTE: To get the most efficient use from your new range hood,

read the "Range Hood Use" section.