Parts supplied for
installation:
anti-tip bracket
2 screws (#10 x 1-1/2")
2 plastic anchors
(Bracket must be securely mounted to sub-floor.
Thickness of flooring may require longer screws to
anchor the bracket to sub-floor.)
Cutout dimensions/requirements
18" (45.7 cm)
min. clearance
upper side
cabinet to
countertop
This shaded area
recommended for
electrical outlet.
Contact a qualified
floor covering
installer to check that
the floor covering
can withstand at
least 200°F (93.3°C).
Use an insulated pad
or 1/4" (6.4 mm)
plywood under
range if installing
range over
carpeting.
Product
dimensions
Not shown:
• literature pack
• orifice spuds
Proper gas supply
connection must be
available. See "Gas
supply requirements, "
Page 4.
Grounded electrical
outlet is required.
See "Electrical
requirements, "
Page 4.
13" (33.0 cm) max.
upper cabinet depth
30" (76.2 cm) min.
cabinet opening width
30-1/8" (76.5 cm)
opening width
2" (5.1 cm) min.
countertop space to
side wall or other
combustible material
10"
24"
(25.4 cm)
(61.0 cm)
5"
2"
(12.7 cm)
(5.1 cm)
5"
5"
3"
(12.7 cm)
(7.6 cm)
26-3/4" (67.9 cm)
depth with handle
24-1/4"
(61.6 cm)
For minimum
clearance to top of
cooktop, see NOTE.***
This shaded area
recommended
for installation of
gas pipe.
Do not seal the range to
the side cabinets.
If cabinet depth is greater
than 24" (61.0 cm), oven
frame must extend
beyond cabinet fronts by
1/2" (1.3 cm) min.
8"
(20.3 cm)
29-7/8" (75.9 cm)
width
Check location where range will be installed. The
range should be located for convenient use in the
kitchen. Recessed installations must provide complete
enclosure of the sides and rear of range.
All openings in the wall or floor where range is to be
installed must be sealed.
IMPORTANT: Some cabinet and building materials are
not designed to withstand the heat produced by the
oven for baking and self-cleaning. Check with your
builder or cabinet supplier to make sure that the
materials used will not discolor, delaminate or sustain
other damage.
***NOTE: 24" (61.0 cm) min. when bottom of wood
or metal cabinet is protected by not less than
1/4" (6.4 mm) flame retardant millboard covered
with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm)
aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) min. clearance between the top of
the cooking platform and the bottom of an
unprotected wood or metal cabinet.
Anti-tip bracket:
The floor anti-tip
bracket must be
installed. To install the
anti-tip bracket
shipped with the
range, see Page 5 and
the anti-tip bracket
template.
36"
(41.4 cm)
cooktop
height
46-1/4" (117.5 cm)
overall height for
tall backguard
models
3
Halaman Cetak