Whirlpool 36'' Freestanding Gas Range Panduan Petunjuk Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kap Ventilasi Whirlpool 36'' Freestanding Gas Range. Whirlpool 36'' Freestanding Gas Range 7 halaman. 30" and 36" gas sealed burner cooktop
Juga untuk Whirlpool 36'' Freestanding Gas Range: Panduan Petunjuk Instalasi (13 halaman), Panduan Petunjuk Instalasi (10 halaman), Panduan Petunjuk Instalasi (7 halaman), Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan (28 halaman), Panduan Petunjuk Instalasi (28 halaman), Panduan Petunjuk Instalasi (6 halaman), Panduan Petunjuk Instalasi (7 halaman), Petunjuk Instalasi (5 halaman)
Halaman Cetak
Before you start...
Check locotion where range will
ALL OPENINGS IN THE WALL
be installed. The location should c OR FLOOR WHERE THE RANGE
Proper lnstallatlon Is your responslblllty.
be away from strong draft areas,
IS TO BE INSTALLED MUST BE
Make sure you have everythlng neces-
such as wlndows, doors, and
SEALED.
sary for correct Installation. It Is the
strong heatlng vents or fans. The
responslblllty of the Installer to comply
range should be located for
wlth the lnstallatlon clearances
specl-
convenient use In the kitchen.
Note: Clearances speclfled are
Recessed installations must
for combustible
walls and
fled on the serlal/ratlng plate. The
serlal/ratlng plate can be found under
provide complete enclosure of
materials that have a density
the cook-top.
the sides and rear of range
of 20 or more pounds per
7
'I
11 cubic foot. No evaluatlon
Fire Hazard
Do Not obstruct the flow of
combustion and ventilation air.
Personal injury Hazard
Avoid installing cabinet storage
above the cooking surface. If
cabinets are already installed.
reduce the hazard of reaching
over a heated cooking surface
by installinga
range hood. The
range hood should extend a
minlmum of 5 inches out from the
bottom front of the cabinets.
Reachlna over a heated cooking
surface could result in a serious -
burn or other personal injury.
Eiectrtcai Shock Hazard
it is the customer's responsibility:
l
To contact a qualified
electrical
installer.
l
To assure that electrical
installation Is adequate
and in
conformance
with National
Electrical Code, ANSVNFPA 70.
latest edition:
and ail local
codes and ordinances.
Failure to do so could result in fire,
eiectrlcai
shock or other personal
in]ury.
of clearances
has been
made for Installations
adJacent to materlals that
are less than 20 pounds
per cu.ft. or to plastic tiles
Cabinet opening dimensions
that are shown must be used.
Given dimenslons provide
0" clearance.
Wait gas Ilne'
opening-
r min.
4' max. from left side
of cabinet
Proper gas
32-518" from floor
suPPlY
.-I
connection
must J--
-I
I
be available. See, 1
Gas supply
requirements.
WARNING: If the.
information
in this manual
is not followed
exactly,
a
fire or explosion
may result
causing
property
damage,
personal
injury or death.
"Note:
30" mln. when
60ttom of wood or meta;
'\ L-\
I
cabinet Is protected by not
\,
less than %"flame retardant
mlllboard covered wtth not
less than No. 21 B MSG sheet
steel, 0.015" stalnless steel,
0.024" aluminum or 0.020"
copper.
5" max. from floor
Do not pinch the
power cord
between the
ranae (
Q - and wall.
seal the
ige to the slde
LI- -.-
36" mln. clearance
between the top of the
coaklng platform and the
boffom of an unprotected
wood or metal cabinet.
The antl-tlp
must be Ins
1 bracket
talled. For
'important: Observe all
see Panel-C.
extend beyond
cabinet fronts
by l/2" mln.
.
Toe pans
-i-
L
-Do
Not store or use
gasoline
or other
flammable
vapors and
liquids in the vicinity
of this
or any other appliance.
-WHAT
TO DO IF YOU SMELL
GAS
IWldth - 36"
electrical
outlet Is required.
See Electrical
requirements.
l
Do Not try to light any
appliance.
l
Do Not touch any
electrical
switch; Do Not
use any phone
in your
building.
l
Immediately
call your
gas supplier from a
neighbor's
phone.
Follow
the gas supplier's
instructions.
l
If you cannot
reach your
gas supplier,
call the fire
department.
-Installation
and service
must be performed
by a
qualified
installer, service
agency
or the gas
supplier.
governing codes and
ordinances. Failure to meet
codes and ordinances could
lead to fire or electrical shock
hazard.
Tools and
materials needed
for Qnstallatfon:
l
hand or electric drill
*wood floors: l/8" drill bit
l
concrete/ceramic
floors: l/4" masonry drill bit
l
gas line shutoff valve'
l
L.P.-reslstant plpe-joint compound
l
AGA deslan-certified
flexible metal connector
Properly Damage
l
Contact a qualified floor covering
installer to check that the floor
covering can withstand heat at least
90°F above room temperature.
l
Use an insulated pad or l/4"
plywood under range if installing
range over carpeting.
Failure to do so may result in damage
to floor covering.
(4-5 feet) -
level
A
Mdbile Home Installation
The installation of this range must
conform to the Manufactured
Home
Construction and Safety Standards,
Title 24 CFR, Part 3280 [formerly the
Federal Standard for Mobile Home
Construction and Safety, Title 24,
HUD Part 280) or when such standard
is not applicable,
the Standard for
Manufactured
Home Installation 1982
(Manufactured
Home Sites,
Communities and Setups), ANSI
2225.1-l 987 or latest edition, or with
local coaes.
When this range is installed in a mobile
home, it must be secured to the floor
during transit. Any method of securing
the range is adequate
as long as It
conforms to the standards listed
a hove
Copies of the standards listed may be
obtained from:
*National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
**American Gas Association
1515 Wilson Boulevard
Arlington, Virginia 22209
flat-b&e
?hllli
s
screwdriver
screkd river
I
measurln
7
tape or ru er
Gas suppliJ
requirements
P I I. i ,..
important: Observe all governlng
codes and ordinances.
Fire Hazard
l
Range must be connected
to a
regulated gas supply.
l
L.P. gas supply must Not exceed a
pressure of 14" water column. This
must be checked by a qualified
technician
before installing this
range.
. Do Not use an open flame to test for
leaks from gas connections.
l
New, A.G.A.-design-certified
flexible
gas line should be used when codes
permit.
Failure to follow these instructions
could result in a fire, explosion or
personal injury.
PANEL A