If range does not operate:
IJ Check that the circuit breaker is not tripped or
the house fuse blown.
q
Check that the power supply cord is plugged
into the wall receptacle.
q
See Use and Care Guide for troubleshooting
list.
If you need assistance:
lf you have questions about operating, cleaning or
maintaining
your range:
q
Refer to Use and Care Guide.
I~J Call the Consumer Assistance Center: Check
your Use and Care Guide for a toll-free number
to call or call the dealer from whom you
purchased this appliance. The dealer is listed in
the Yellow Pages of your phone directory under
"Appliances - Household -Major
- Service
and Repair."
If you need service:
Maintain the quality built into your range by calling an
authorized service company.
To obtain the name and number of the authorized
service company:
I~J Contact the dealer from whom you purchased
your range; or
q
Look in the Yellow Pages of your telephone
directory under "Appliances - Household -
Major-Service
and Repair;" or
I~J Call the Consumer Assistance Center.
The toll-free number is listed in your Use and
Care Guide.
When you call, you will need:
l7J The range model number.
l7J The range serial number.
Both numbers are listed on the model/serial rating
plate, located on the oven frame behind the oven door.
Part No. 3189985
0 1995
Moving the range:
two or more people are required to move it.
All ranges can tip.
Do Not step, lean or sit on the range drawer or
door.
The anti-tip device packed with range must be
installed. See Installation Instructions.
Failure to follow these instructions
could result
in injury and/or product damage.
When moving range, slide range onto cardboard or
hardboard -to
prevent damaging the floor
covering.
If removing the range is necessary for cleaning or
maintenance:
1. Disconnect the electrical supply. If necessary, pull
the range out, away from the wall, just far
enough to disconnect the electrical supply line.
2. Remove range to complete cleaning or
maintenance.
3. Move range back into operating position.
Remove drawer or look underneath range
(a flashlight may be needed). Check that leveling
leg is engaged in anti-tip bracket. If leveling leg is
not properly engaged, remove and reposition
bracket to insure that leveling leg fits properly in
bracket.
4. Check that range is level.
5. Reconnect the electrical supply.
Benton Harbor, Michigan 49022
Printed in U.S.A.
Halaman Cetak