Whirlpool AKR 968 Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Kap Ventilasi Whirlpool AKR 968. Whirlpool AKR 968 8 halaman.

Halaman Cetak

Maintenance

Important! Always disconnect the hood before

cleaning or carrying out maintenance by unplugging it

or switching off the power supply.

Grease filter maintenance

Retains fat particles produced during cooking.

Wash the metal grease filter once a month (or when the filter

saturation system indicates cleaning is necessary) with a mild

detergent, by hand or in a dishwasher using a low

temperature and a short wash cycle.

Cleaning in a dishwasher may cause the metal grease filter to

discolour, but this in no way affects its filtering efficiency.

Remove the grease filter - Fig. 2

Remove the grease filter by turning the knobs (g) that secure

it to the hood through 90°, then remove downwards.

To refit the grease filter proceed in reverse order.

Carbon filter maintenance

Retains any unpleasant odours produced during

cooking.

Unlike traditional carbon filters, this carbon filter can be

washed and reactivated.

With normal hood use, the filter should be cleaned once a

month. The best way to clean the filter is in a dishwasher at

the highest temperature possible, using a normal dishwasher

detergent. To avoid particles of food or dirt settling on the

filter during washing and giving rise to unpleasant smells, it is

advisable to wash the filter on its own. After washing, dry the

filter in the oven at 100°C for 10 minutes to reactivate it.

The filter will retain its odour-absorbing capacity for three

years, after which it must be replaced.

Fitting the carbon filter - Fig. 3

Remove the grease filter.

Position the wadding around the grease filter and secure it in

place using the securing device.

Fit the top plug and secure in place with the retaining spring.

Refit the grease filter complete with the carbon filter.

To remove, proceed in reverse order.

Replacing bulbs - Fig. 4

Disconnect the appliance from the power supply.

Important! When replacing the bulbs, first ensure that they

are cold.

Use a small screwdriver or any other suitable tool to prise

off the lamp cover.

Remove the burnt-out bulb.

Replace using 12V -20W max - G4 halogen bulbs only,

taking care not to touch them with your hands.

Close the lamp cover (snap-on).

If the lamps are not working, check that they are fitted

properly in place before contacting the After Sales Service.

5019 318 33259

Fig.2

Fig.3

Fig.4