Whirlpool AKR 996 Lembar Data Instalasi - Halaman 28

Jelajahi secara online atau unduh pdf Lembar Data Instalasi untuk Kap Ventilasi Whirlpool AKR 996. Whirlpool AKR 996 28 halaman.

Halaman Cetak

1. Installation Data Sheet

31833160.fm Page 28 Friday, April 1, 2005 6:48 PM

AKR 631-666-812-966

AKR 943-948-952-995-996

Important - upon initial installation:

Selecting the hob type: to ensure accurate

"reading" by the sensors, the latter must be calibrated

to suit the type of hob as follows: with the hood OFF,

press buttons 3 and 4 at the same time until either

LED F for gas hobs, LED G for induction hobs or

LED H for electric hobs lights up.

Automatic and manual sensor calibration: the

hood automatically "calibrates" sensor operation, but

under certain circumstances (e.g.: in the event of a

prolonged power failure or upon initial installation)

calibration can be carried out manually, with the hood

OFF, by pressing buttons 5 and 6 at the same time for

more than 3 seconds, otherwise you can wait until the

hood carries out calibration automatically.

Maintenance

ALWAYS disconnect the hood from the mains before

performing maintenance.

Wash the grease filter and the carbon filter in a

dishwasher once a month, at the highest possible

temperature, using normal dishwasher detergent. It is

recommended to wash the filters on the their own.

After washing, reactivate the carbon filter by drying

it in the oven at 100 °C for 10 minutes. Fit a new

carbon filter every 3 years.

Remove the grease filters - Fig. 1: push the spring

release handle backwards (f1) then remove the filter

downwards (f2).

Clean the perimeter extraction panel

(if provided) as often as the grease filter, using a

cloth and a mild liquid detergent.

Never use abrasive substances.

Clean the sensor plate regularly.

Replacing bulbs

Use a small screwdriver or any other suitable tool

to prise off (m-Fig. 1) the lamp cover (p-Fig.1).

Remove the burnt-out bulb.

Use max 20 W halogen bulbs only, taking care not

to touch them with your hands.

Close the lighting unit (snap-on).

Fitting the carbon filter:

Remove the grease filter (f1/f2 - Fig. 1).

Remove the filter holder by turning the knobs

(g - Fig. 2) through.

Fit the carbon filter (i - Fig. 2) in the filter holder

(h - Fig.2).

Reverse the above procedure to re-fit the filter holder

and grease filter.

5019 318 33160

Fig. 1

* Only present on some models

H RUS BG

Fig. 2