Whirlpool Slide-Out Range Hood Panduan Instalasi dan Penggunaan - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Penggunaan untuk Kap Ventilasi Whirlpool Slide-Out Range Hood. Whirlpool Slide-Out Range Hood 36 halaman. 30" (76.2 cm) and 36" (91.4 cm) slide-out range hood

Halaman Cetak

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Level

Drill

1 " drill bit

" (8 mm) nut driver or ratchet

Pencil

Pliers

Wire stripper or utility knife

Tape measure or ruler

Caulking gun and weatherproof caulking compound

Phillips screwdriver

Flat-blade screwdriver

Saber or keyhole saw

Vent clamps

Metal snips

Parts needed

Home power supply cable

Two

" (12.7 mm) UL listed or CSA approved strain reliefs

For vented installations, you will also needed:

1 wall or roof cap

Metal vent system

For non-vented (recirculating) installations, you will also

need:

Charcoal Filter Kit Part Number 883140. See "Assistance or

Service" section to order.

Optional parts needed:

Wood filler strips for cabinets with recessed bottoms. Length

and thickness determined by recess dimensions. See

"Prepare Location" section.

Two, 1" x 1" x 5" (25.4 x 25.4 x 127 mm) wood pieces for

cabinet floor. See "Prepare Location" section.

Four, 1 " (31.8 mm) wood screws

Parts supplied

Remove parts from packages. Check that all parts are included.

2 screws

Damper

Plastic cover (used for customized front panel)

Hardware package

INSTALLATION REQUIREMENTS

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Have a qualified technician install the range hood. It is the

installer's responsibility to comply with installation clearances

specified on the model/serial rating plate. The model/serial rating

plate is located behind the left filter on the rear wall of the range

hood.

Range hood location should be away from strong draft areas,

such as windows, doors, and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given

dimensions provide minimum clearance. Consult your cooktop/

range manufacturer installation instructions before making any

cutouts.

Grounded electrical outlet is required. See "Electrical

Requirements" section.

The range hood is factory set for vented installations through the

roof or wall. For non-vented (recirculating) installations see "Non-

Vented (recirculating) Installation Through the Soffit/Cabinet" in

the "Prepare Location" section. Charcoal Filter Kit Part Number

883140 is available from your dealer or an authorized parts

distributor.

All openings in ceiling and wall where range hood will be installed

must be sealed.

For Mobile Home Installations

The installation of this range hood must conform to the

Manufactured Home Construction Safety Standards, Title 24

CFR, Part 328 (formerly the Federal Standard for Mobile Home

Construction and Safety, title 24, HUD, Part 280) or when such

standard is not applicable, the standard for Manufactured Home

Installation 1982 (Manufactured Home Sites, Communities and

Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local

codes.