Whirlpool UXI6536BSS Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan - Halaman 13
Jelajahi secara online atau unduh pdf Petunjuk Pemasangan Dan Panduan Penggunaan & Perawatan untuk Kap Ventilasi Whirlpool UXI6536BSS. Whirlpool UXI6536BSS 32 halaman. 36" (91.4 cm) island-mount canopy range hood
Juga untuk Whirlpool UXI6536BSS: Petunjuk Pemasangan Dan Panduan Penggunaan Dan Perawatan (32 halaman)
Halaman Cetak
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease
filters before operating hood.
Exterior Surfaces
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water, or all-purpose cleanser
■
Wipe with damp soft cloth or nonabrasive sponge,
■
and then rinse with clean water and wipe dry.
Metal Grease Filter
1. Remove the filter by pulling the spring release handle
and then pulling down the filter.
A
A. Spring release handle
2. Wash metal filter as needed in dishwasher or hot
detergent solution.
3. Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
4. Push in spring release handle.
5. Push up on metal filter and release handle to latch into place.
Non-Vented (recirculating) Installation Filters
The charcoal filter is not washable. It should last up to
6 months with normal use. Replace with Charcoal Filter
Kit Number W10412939.
To replace charcoal filter:
1. Remove metal grease filter from range hood.
See "Metal Grease Filter" in this section.
2. Bend spring clips away from metal grease filter.
3. Place charcoal filter into top side of metal filter.
RANGE HOOD CARE
Cleaning
4. Bend spring clips back into place to secure the
5. Replace metal grease filter. See "Metal Grease Filter"
Replacing a Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool.
To avoid damage or decreasing the life of the new bulb,
do not touch bulb with bare fingers. Replace bulb, using
tissue or wearing cotton gloves to handle bulb.
If new lights do not operate, make sure the lamps
are inserted correctly before calling service.
1. Disconnect power.
2. Use a flat-blade screwdriver and gently pry
3. Remove the lamp and replace with a 120-volt, 40-watt
4. Replace the light cover.
5. Reconnect power.
charcoal filter to the metal filter.
in this section.
the light cover loose.
maximum, halogen lamp made for a G-9 base.
13