Clarion AX430 Panduan Pemilik - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penerima Mobil Clarion AX430. Clarion AX430 12 halaman. Am/fm cassette player with cd changer control
Halaman Cetak8. IN CASE OF DIFFICULTY
Problem
Power does not turn on.
(or no sound is produced.)
Sound quality is poor.
No sound while unit can
be operated.
9. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
Error Display
ERROR 1
Tape cannot be played due to defective
tape such as cut tape.
ERROR 2
Tape is caught and cannot be played.
ERROR 4
Tape mode cannot be detected.
ERROR 8
Tape is caught and cannot be ejected.
ERROR 2
A CD inside the CD changer is not
loaded.
ERROR 3
A CD inside the CD changer cannot be
played due to scratches, etc.
ERROR 6
A CD inside the CD changer cannot be
played because it is loaded upside-
down.
If a display other than one of the displays above appears, press the reset button. If the problem per-
sists, turn the power off and contact your store of purchase.
Cause
Fuse is blown.
Connections are improper.
Playback head is dirty.
Power ANT lead is shorted
to the ground.
Cause
Measure
Replace with a fuse of the same
amperage as the old fuse.
Read the attached "Installation/Wire
Connection Guide" once again and
wire properly.
Use a cleaning tape, etc. to clean the
head.
Turn the unit off, first.
Remove all connecting wires from the
power ANT lead, and turn the unit on,
then re-connect a wire one by one to
the power ANT lead.
When sound is muted again, check
the unit with a wire connected last.
Measure
Eject the tape then replace it with a new
one.
Remove the caught or wound tape.
This is a failure of tape mechanism and
consult your store of purchase.
Eliminate the reason for which the tape
is caught.
This is a failure of CD changer's mecha-
nism and consult your store of pur-
chase.
Replace with a non-scratched, non-
warped disc.
Eject the disc then reload it properly.
13
AX430