Bad Boy 7800670 Panduan Operator - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Operator untuk Mesin Pemotong Rumput Bad Boy 7800670. Bad Boy 7800670 20 halaman. 21-inch variable speed swivel wheel walk behind mower

Halaman Cetak

Troubleshooting

PROBLEM
Engine Will Not Start
1. Fuel tank empty.
Using Recoil Starter
2. Engine needs priming.
3. Spark plug wire disconnected.
Engine Stalls or Stops
1. Blade control is released or is not being held
After Running
securely against handle.
2. Fuel tank empty.
3. Engine air pre-cleaner and or air cleaner dirty. 3. Clean free of all debris.
4. Spark plug defective or gap set improperly.
5. Water, debris or stale fuel in fuel system.
Engine Loses Power
1. Engine air pre-cleaner or air cleaner dirty.
2. Spark plug faulty.
3. Water, debris or stale fuel in fuel system.
Excessive Vibration
1. Damaged, out of balance or bent mower
blade.
2. Loose blade components.
3. Loose or missing air lift (if equipped).
4. Lumpy or frayed belt.
Mower Will Not Move
1. Build-up of debris on or around wheel drive
Loss Of Traction
components.
2. Transmission clutch cable adjustment
required.
3. Drive belt requires replacement.
4. Damaged transmission.
Transmission Noise
1. Transmission clutch cable adjustment
required.
2. Damaged transmission.
Ground Speed
1. Build-up of debris on or around ground speed
Too Fast / Too Slow;
control components.
Unable to Adjust
2. Ground speed control adjustment required.
Ground Speed
3. Drive belt requires replacement.
4. Damaged transmission.
Cutting Grass
1. Cutting height too low or high.
Improperly
2. Forward ground speed too fast.
3. Terraced cut, side to side.
4. Excessive deck pitch, front to rear.
5. Cutting blade dull or damaged.
Poor Grass Discharge 1. Forward speed too fast.
2. Grass is wet.
3. Excessively worn or damaged blade.
4. Build up of grass clippings and debris under
deck.
5. Improper blade installed on deck.
6. Blade installed improperly on deck.
Oil Leaking
1. Leaking engine case.
PROBABLE CAUSE
CORRECTIVE ACTION
1. Fill fuel tank with fresh fuel.
2. Prime. Check Engine Manual for Instructions.
3. Place spark plug wire onto spark plug.
1. Blade control should be held securely against
handle at all times during operation of mower.
2. Fill with fuel to proper level.
4. Service spark plug.
5. Drain and clean fuel system.
1. Clean or replace filters.
2. Service spark plug.
3. Drain and clean fuel system.
1. Service mower blade.
2. Service and tighten loose parts.
3. Replace air lifts. Tighten to proper torque.
4. Replace belt.
1. Clean debris.
2. Adjust transmission clutch cable.
3. Replace drive belt.
4. Contact authorized dealer.
1. Adjust transmission clutch cable.
2. Contact authorized dealer.
1. Clean debris.
2. Adjust ground speed control.
3. Replace drive belt.
4. Contact authorized dealer.
1. Adjust cutting height.
2. Move ground speed control to a slower speed.
3. Adjust height of cut with height adjust levers.
4. Adjust height of cut with height adjust levers.
5. Sharpen cutting edges or replace blade.
1. Move ground speed control to a slower speed.
2. Mow when grass is dry.
3. Service mower blade.
4. Clean deck.
5. Install proper blade.
6. Install blade properly.
1. Contact authorized dealer.
2. Check and tighten drain plug.
3. Make sure dip stick or oil filler cap is securely
in place.
17