Firetide HotPort 6101 Panduan Pemasangan Perangkat Keras - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Perangkat Keras Jaringan Firetide HotPort 6101. Firetide HotPort 6101 20 halaman. 6100 series
Juga untuk Firetide HotPort 6101: Panduan Instalasi Cepat (2 halaman)

Halaman Cetak

Power Options - Outdoor Nodes

Power Supply

The power supply can provide power to the HotPort enclosure from
an AC outlet. The power supply is rated for 90-240 VAC.
Powering Other Ethernet Devices
Ports 2 and 3 on a 6200 Series node can provide Power over Ether-
net (PoE) functionality to Powered Devices (PD) connected to these
ports. (Port 1 cannot.) A Powered Device can receive data and the
power to process the data from the HotPort node, which functions
as Power Sourcing Equipment (PSE) in this configuration. To re-
ceive power from a HotPort node, the device must support the IEEE
802.3af standard, which defines PoE functionality.

Building a Custom Ethernet Cable

Firetide supplies a cable that will connect your 6200 Series node
directly to a HotPoint Access Point. To connect to other devices, you
will need to assemble an adapter cable. To assist in this, Firetide
supplies a weatherized Ethernet transition cable, which is PoE com-
patible. A weatherized RJ-45 coupler is also included.
To connect power to the unit from PSE:
1.
Construct a shielded Category 5 Ethernet cable:
2.
Insert one end of the Ethernet cable (without an RJ-45 connec-
tor) through the provided coupler housing.
3.
Use an RJ-45 crimping tool to attach an RJ-45 connector to this
end of the Ethernet cable.
4.
Insert the male RJ-45 connector on the constructed Ethernet
cable into the female-to-female Ethernet coupler.
5.
Connect the male RJ-45 connector on the Firetide-supplied
Ethernet transition cable to the female-to-female coupler.
6.
Remove the protective cap from an Ethernet port on the Hot-
Port enclosure and insert the circular, 10-pin connector on the
Ethernet transition cable.
7.
Tighten all connectors to ensure a watertight seal.
February 2007

DC Power

In addition to its AC input, the 6200 Series features a DC input. It
is compatible with older 3200 Series external power supplies, so if
you are upgrading an older node, you may re-use the supply if con-
venient.
The 6200 Series does not care what the source of DC power is. If de-
sired, you may use batteries, solar panels, or any other source of DC
power at the correct voltage. Contact your Firetide dealer for more
information on their solutions.
Do not connect both AC and DC supplies simultaneously.
Note: Regardless of your exact configuration of Ethernet cable and
power sources, you must make sure all cables and connections are
completely waterproofed. It is a good installation practice to leave
enough cable slack so that there is a drip loop in each cable. This pro-
vides a low point for water to drip off the cable, rather that running
down to a connector.
Figure 1. Waterproof Ethernet Cable
Figure 11.
Waterproof RJ- Coupler
Firetide Instant Mesh Networks 1