Ergo EMPRO-WM175B Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Rak dan Dudukan Ergo EMPRO-WM175B. Ergo EMPRO-WM175B 13 halaman. Flat panel swing out arm

Halaman Cetak

Attaching the Flat Panel to the Wall Plate

Two people are required for this step.

Upper

Mounting

Bar

NB. Do not release the fl at panel until verifying

the connection between the universal mounting

Lower

brackets and the upper and lower mounting bars.

Mounting

Bar

Flat Panel

Place the universal brackets and the fl at panel over

and onto the upper and lower mounting bars of the

EMPRO-WM175B and lower it down. Do not release

the fl at panel until the fl at panel is resting securely

on the upper and lower mounting bars.

Securing and Levelling the Flat Panel

Screwdriver

In the event that the fl at panel is tilted too far to

Levelling

one side, the levelling screws will allow you to

Screw -

compensate for this tilt by simply adjusting the

Pre-installed

screws with a screwdriver. (see illustration for a

clearer view).

Use a screwdriver to adjust the two M6 x 30 levelling

1 1

screws, located on the top of the mounting brackets.

Once the fl at panel is level, use a screwdriver to

tighten the two M6 x 30 locking screws, located on

Locking

Screw -

the bottom of the mounting brackets. Do not over

Pre-installed

tighten these screws.

Adjusting the Flat Panel Tilt

NB. To adjust the tilt tension of the EMPRO-WM175B,

loosen the tension bolts located on the bottom right

and left side of the main arm assembly. Re-tighten these

bolts to achieve your desired tension.

Tension Bolt

Adjusting the Flat Panel Down

Place one hand at the centre top edge of the fl at

1 1

panel.

Place the other hand on the centre bottom edge of

the fl at panel.

Using the upper hand, gently pull the top of the

fl at panel away from the wall while the lower hand

gently pushes the bottom of the fl at panel towards

the wall.