AlcoMate AL6000 Lite Panduan Operator - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Operator untuk Peralatan Uji AlcoMate AL6000 Lite. AlcoMate AL6000 Lite 8 halaman. Digital personal breathalyzer
Juga untuk AlcoMate AL6000 Lite: Panduan Pengguna (4 halaman)

Halaman Cetak

Warnings and Precautions



WAIT AT LEAST 20 MINUTES AFTER EATING OR DRINKING BEFORE TESTING. A breathalyzer

examines "lung air" samples, not "mouth air" to calculate alcohol content. Any "contaminants" in the

mouth, including alcohol, food, smoke, or even excess saliva, may interfere with testing. This

includes alcohol-based mouthwash or similar products. This is the most common cause of improper

use and incorrect results.



Avoid testing in high wind or enclosed spaces. Poor ventilation may also lengthen the time required

for warm up between tests.



Do not blow smoke, saliva or other contaminants into the mouthpiece, as the sensor may become

damaged.



Do NOT use the AlcoMate Core as a tool to drink and drive.



Keep out of extreme temperatures and out of the reach of children.



To maintain accuracy, the sensor inside the AlcoMate Core must be recalibrated every 200 tests or

at least once a year (whichever comes first). Large numbers of "high positive" (high alcohol)

readings may require recalibration of the sensor much sooner than normally expected. To

recalibrate, you must mail your device to the address at the end of this manual. Please contact us

for details and related fees.

Troubleshooting



WARNING DISPLAY "Flo": If you see "Flo" in the display, the breath sample was not strong or long

enough for measurement. Please try again and make sure the breath is strong and steady during

sampling. As soon as you start blowing into the device, you will hear a long beep indicating how long

you should blow.



WARNING DISPLAY "SEn": If you see "SEn" in the display, there is a general sensor module error.

Please contact us for technical service.



WARNING DISPLAY "bAt": If you see "bAt" in the display, the battery power is low. Please replace

the batteries with a brand new pair. Make sure to properly align the batteries by looking at the +/-

marks.



WARNING DISPLAY "Err9": Power source is too weak to complete operation. Please replace

batteries with a new pair.



For the other troubles, please contact AK GlobalTech at [email protected], along with your

error codes and photos if available.

- Warnings and Error Codes -