Xerox 6180N - Phaser Color Laser Printer Panduan Memulai - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Printer Xerox 6180N - Phaser Color Laser Printer. Xerox 6180N - Phaser Color Laser Printer 37 halaman. Color laser printer
Juga untuk Xerox 6180N - Phaser Color Laser Printer: Panduan Instalasi (34 halaman), Lembar Spesifikasi (2 halaman), Panduan Pengguna (32 halaman), Panduan Pengguna (28 halaman), Instal Manual (2 halaman), Manual Keamanan (38 halaman), Catatan Rilis (2 halaman), Instal Manual (2 halaman), Manual (34 halaman), Manual (34 halaman), Panduan Memulai (34 halaman), Panduan Pengguna (32 halaman), Panduan Instalasi dan Pengoperasian (8 halaman), Panduan Evaluator (16 halaman), Spesifikasi (4 halaman)

Halaman Cetak

Xerox 6180N - Phaser Color Laser Printer Panduan Memulai

XEROX DOCUMENT SERVICES PLATFORM SERIES

GETTING STARTED

2. Type mount /XRXbackup to mount the backup

3. Type cd /XRXbackup.

4. Copy or ftp the backup files to the /XRXbackup

♦

If it is desirable to store the system backup files to tape,

refer to the Tools and Utilities section of this document for

the TGBackup procedure.

♦

When restoring a system backup, a DocuSP System

Restore CD is provided with the software kit to your Xerox

Service Representatie. Performing the following to start

the Restore procedure:

1. Insert DocuSP System Restore CD in the CDROM

2. Shutdown the DocuSP controller by selecting

3. At the ok> prompt, type boot cdrom.

4. During the system restore process, a series of

♦

If a system restore is being performed following a fatal

disk failure or replacement of the hard disks, a DocuSP

clean install must be performed first to partition the hard

drives and create the partitions. Following the clean

install, copy the backup files to the /XRXbackup partition

then perform the system restore.

♦

For a configuration backup, do not use the /XRXbackup

partition to store the configuration files. The configuration

backup files can be stored on the DocuSP internal disk,

an external disk, an NFS mounted network drive, or

supported media such as a floppy drive or CDROM R/W.

Saving stock and tray mappings

DocuSP 4.1 now provides the ability to save the current paper

tray programming to a file and recall that file for later use. The

saved tray mappings may also be copied to another DocuSP-

based system using the DocuSP Backup and Restore

functionality.

For example, if a job or series of jobs that are often run have a

specific paper tray programming, the mapping can be saved and

recalled for faster setup for printing of the job.

This functionality is not available on the DocuColor iGen3.

partition.

partition from the storage location.

drive.

Shutdown from the DocuSP user interface.

questions displays asking if you wish to create a new

file system. Enter yes.

DOCUSP 4.1