Xerox Phaser II DX Lembar Instruksi - Halaman 25

Jelajahi secara online atau unduh pdf Lembar Instruksi untuk Printer Xerox Phaser II DX. Xerox Phaser II DX 25 halaman. 4-mbyte ram simm installation

Phaser 200e: Insert a memory module in connector J6 (a), and tilt the

module upright until it locks in place (b).

When properly inserted, a tab on each end of the connector slips into a

hole on each end of the RAM SIMM. Also, a pawl on each end of the

connector latches around each end of the RAM SIMM to lock it in

place.

Phaser 200i: Insert a memory module in connector J6 (or in J7 if J6 is

already ﬁlled) (a), and tilt the module upright until it locks in place

(b).

When properly inserted, a tab on each end of the connector slips into a

hole on each end of the RAM SIMM. Also, a pawl on each end of the

connector latches around each end of the RAM SIMM to lock it in

place.

Phaser 200i only. Repeat Step 8 to install an additional memory

module in J7 if a second SIMM is available.

10.

Reinstall the image processor board in the card cage.

11.

Reinstall the I/O board.

12.

Close and secure the card cage top. Reinstall the rear cabinet panels.

13.

Reconnect the host interface cables. Turn on the printer and make a

print to verify that the printer functions correctly.

4-Mbyte RAM SIMM Installation — (4690F4M)

RAM

SIMMs

8699-65