Xerox WORKCENTRE 7120 Panduan Referensi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Referensi untuk Printer Xerox WORKCENTRE 7120. Xerox WORKCENTRE 7120 30 halaman. Color networking mfp a3
Juga untuk Xerox WORKCENTRE 7120: Panduan Evaluator (25 halaman), Panduan Evaluator (24 halaman), Spesifikasi (14 halaman), Spesifikasi (14 halaman), Perbandingan Kompetitif (11 halaman), Perbandingan Kompetitif (11 halaman), Brosur & Spesifikasi (4 halaman), Panduan Referensi (29 halaman), Panduan Penggunaan Cepat (20 halaman), Panduan Penggunaan Cepat (20 halaman), Panduan Penggunaan Cepat (20 halaman), Panduan Penggunaan Cepat (20 halaman), Panduan Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Penggunaan Cepat (20 halaman), Panduan Referensi (32 halaman), Panduan Administrator Sistem (20 halaman)

Halaman Cetak
Xerox WORKCENTRE 7120 Panduan Referensi

CUSTOM MEDIA SIZE

This command specifies the custom media size on which to print the job. Insert a media size command within the PCL
portion of the print job.
PCL
Width of Custom Paper is specified by <ESC>&f#I
where # = decipoints for (89 - 297)mm .
Length of Custom Paper is specified by <ESC>&f#J
where # = decipoints for (98 - 432)mm.
For example:
4.25-inch x 5.5-inch will give <ESC>&f3060I3960J
by
4.25-inch x 720 decipoints/inch = 3060
and
5.5-inch x 720 decipoints/inch = 3960.

MEDIA SOURCE

This command specifies the tray to supply the job's media.
PJL
@PJL SET MEDIASOURCE = value
Where value is one of the following:
TRAY1 = Feed from paper tray1
TRAY2 = Tray2
TRAY3 = Tray3
TRAY4 = Tray4
TRAY5 = Tray5(Bypass)

OUTPUT LOCATION

Indicates the output bin where the print job is sent.
PJL
@PJL SET OUTBIN = value
Where value is one of the following:
MAINTRAY = Center Tray
MAINTRAY2 = Center Tray - Upper
OUTBIN101 =
Finisher Tray (w/ A-Finisher or SB-Finisher)
BOOKLETTRAY =
Right Bottom Tray(Booklet Maker) (w/ SB-Finisher and
booklet module)
dc10cc0466
Customer Support
PCL
<ESC>&l intH
Where int is one of the following:
0 = Feed paper from default tray
4 = Tray1
1 = Tray2
5 = Tray3
8 = Tray4
20 = Auto
2 or 3 = Tray5 (Bypass)
PCL
<ESC>&l int G
Where int is one of the following:
0 = Automatic Selection
1 = Center Tray
4 = Center Tray - Upper
6 = Finisher Tray (w/ A-Finisher or SB-Finisher)
Page 9