Xerox Fiery EXP4110 Catatan Rilis Pelanggan - Halaman 4
Jelajahi secara online atau unduh pdf Catatan Rilis Pelanggan untuk Semua dalam Satu Printer Xerox Fiery EXP4110. Xerox Fiery EXP4110 24 halaman. Server & controller solutions printing from mac os
Juga untuk Xerox Fiery EXP4110: Panduan Untuk Operator (1 halaman), Opsi Cetak (24 halaman), Manual Pencetakan (24 halaman)
Halaman Cetak
Page 4
Garbled diagnostic message (Brazilian Portuguese)
In the Brazilian Portuguese server, if you right-click FieryBar and choose
Run Diagnostics >Test I/F board, the message that appears is garbled.
Time synchronization
In local Setup, when you specify a time server for synchronizing the date and time for the first
time (General Setup > Date/Time), the system time of the Fiery EXP4110 does not
synchronize and the server name does not appear on the Configuration page. Also, the
Windows Time Service does not stop when you clear the Set Time and Date Automatically
option. As a workaround, manually set the time and date, and then select Set Time and Date
Automatically in Setup.
Settings for PostScript and PCL
When you make a setting for the Offset Mode option in PS Setup, the settings might not
change. This happens because the values are determined by the settings indicated in PCL
Setup. Because PCL settings are saved after PS settings in Fiery Setup, PS settings are always
overridden.
Network
Ethernet speed
The Ethernet Speed option in Network Setup on the Fiery EXP4110 Control Panel lists two
choices that are not supported: 10BASE-TX (Full Duplex) and 100BASE-TX (Full Duplex).
It does not list a choice for 1 Gbit per second (1 Gbps). To set the speed to 1 Gbps, use
Configure.
NDS Setup
To enable PServer Mode and NDS in Network Setup, first select the Enable PServer Mode
option, and then wait until the cursor returns to the Idle state before you select the Enable
NDS option.
IPX Frame type
In Configure > Network Setup, you can select multiple IPX Frame types. However, Network
Setup on the Fiery EXP4110 Control Panel allows you to select only one IPX Frame type.
If you select multiple types through Configure, only one is shown in the Fiery EXP4110
Control Panel.
Maximum number of users for SMB
The Fiery EXP4110 supports a total of eight simultaneous SMB connections, including the
Direct connection, Print queue, and Hold queue.
Part Number: 45051581