Direct power BC185J Panduan Keselamatan dan Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Keselamatan dan Pengoperasian untuk Melihat Direct power BC185J. Direct power BC185J 17 halaman. 7 1/4" circular saw

Halaman Cetak

OPERATING INSTRUCTIONS

1. ADJUSTMENTS

With this saw there are two things you can adjust:

the blade cutting depth and the mitre cutting

angle.

2. CUTTING DEPTH ADJUSTMENT (See ﬁg2)

1.To adjust the blade cutting depth, face the saw

away from you.

2.Loosen the cutting depth adjustment screw

which is located at the back of the saw guard.

3.Hold the baseplate ﬂat against the edge of the

workpiece and lift the main body until the blade is

at the required depth.

4.Firmly tighten the cutting depth adjustment

screw.

3. MITRE CUTTING (See ﬁg3a,ﬁg 3b)

1.Loosen the mitre cutting adjustment knob which

can be found at the front and back of the metal

base plate.

2.Twist the main body until the required angle is

reached. Use the mitre adjustment guide to help

set the required angle.

3.Tighten the screw to secure the baseplate.

4. USING THE CIRCULAR SAW

SWITCHING ON (See ﬁg4)

1.Connect the plug to the mains power supply.

2.Make sure your circular saw switch is locked off

to prevent accidental starting.

To start the unit, press and hold the safety button,

then press the trigger switch.

SWITCHING OFF

To switch off the unit, release the trigger switch.

The blade may continue to rotate after the trigger

switch has been released. Wait until the unit has

come to a complete stop before setting down.

5. USING THE PARALLEL FENCE (See ﬁg5)

A parallel fence allows you to make parallel cuts

in sheets of wood, which are consistently the

same width.

1.Slide the parallel fence into position.

2.Adjust the fence to the required width, and

secure by tightening the parallel fence securing

screw.

When you now use the saw, ensure that the edge

CIRCULAR SAW

Fig 2

Fig 3a

Loosen

Fig 3b

Fig 4

BC185J

Loosen