Xerox 470 Panduan Pemasangan Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemasangan Cepat untuk Mesin fotokopi Xerox 470. Xerox 470 38 halaman. Macintosh driver information
Juga untuk Xerox 470: Manual Informasi (13 halaman)

Halaman Cetak
Xerox 470 Panduan Pemasangan Cepat
100BaseT Ethernet or Token Ring Interface Quick Install Card
Xerox Document Centre 460/470 ST
Before You Connect to a 100BaseT
Ethernet Network
For instructions on how to connect to a Token
Ring network, see the reverse side of this card.
The Document Centre Ethernet Interface has
speed settings of 10MBPS (10 Megabits per
second), 100MBPS (100 Megabits per second)
and Auto (AutoSensing).
If your network has hubs or concentrators that
have Auto-Sensing enabled, it is possible that if
the Document Centre is set to Auto, the hub/
concentrator will not arbitrate to the correct
speed.
Before you connect the printer to your network,
perform the procedure in the next column on this
page entitled Go to the printer and...
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797
Canada: 1-800-939-3769
Go to the printer and...
1.
Enter the Tools pathway
a)
Press the Access ( ) button.
b)
On the keypad enter 1111 or the
current password. Press the Enter
button when finished. Press the Go to
Tools button.
c)
The Touch Screen will be used for the
remainder of the data entry.
2.
Set or Change the Ring Speed or Source
Routing
a)
Press the Connectivity and Network
Setup button.
b)
Press the Physical Media button.
c)
Press the Ethernet button.
NOTE:Auto-Sensing hubs may not arbitrate
correctly with the Document Centre when
Auto is selected. If your hubs/concentrators
support the 100BaseT speed it is recom-
mended you select 100MBPS in Step d
below. (Be sure your Ethernet cable is Cat-
egory 5)
d)
Select the desired Speed (10MBps,
100MBps, or Auto).
e)
When finished with your changes
press Save.
Page 1
3.
Exit the Tools menu
a)
Press the Exit Tools button.
4.
Wait a MINIMUM of 7 minutes for the
printer to reset.
a)
Obtain a Configuration Report page
from your printer and verify that your
settings have been retained.
5.
Connect your Document Centre to the
network with the appropriate cabling.