Xerox 470 Panduan Pemasangan Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pemasangan Cepat untuk Mesin fotokopi Xerox 470. Xerox 470 38 halaman. Macintosh driver information
Juga untuk Xerox 470: Manual Informasi (13 halaman)

Halaman Cetak

Static (Manual) TCP/IP Addressing Quick Install Card

Xerox Document Centre 460/470 ST

Set the Subnet Mask and Gateway

Press the Subnet and Gateway

button.

Press the soft buttons on the Touch

Screen one at a time for each octet of

the Subnet Mask and enter the

numbers using the keypad. Repeat

this process for the IP Gateway

address. When finished press Save to

record the changes and exit to the

TCP/IP Settings screen.

NOTE: The Broadcast Address will be calcu-

lated automatically.

Enable lp or lpr printing (skip steps 7a-

7b if you DO NOT want to print using lp or

lpr).

Press the TCP/IP - Line Printer

button. At the next screen press the

Enable button.

NOTE: While you can change the port num-

ber at which your Document Centre

will accept lpr print jobs it is recom-

mended that you do this ONLY with

extreme caution as most lpr spoolers

are set to send print jobs to the default

port.

If you wish to change the lpr port for

your printer press the port soft button

and enter the desired port number at

the keypad. Press Save.

Exit the Tools Menu

Press the Exit Tools button.

Page 2

Go to a workstation and...

Create a test job and send it to the printer

with an lpr utility or through a queue your

operating system may support.

Check your test job for quality and use the

problem solving section of the Document

Centre 460/470 Reference Guide for

resolving print defects.

If your print job does not print, refer to the

troubleshooting section in the document

entitled Network Installation and

Troubleshooting Guide to correct the

problem.

Repeat this Go to a workstation and...

procedure at each workstation that will

print to this printer.