Xerox Document Centre 230 Panduan Pemasangan Cepat - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pemasangan Cepat untuk Mesin fotokopi Xerox Document Centre 230. Xerox Document Centre 230 8 halaman. Xerox document centre 230: install guide
Juga untuk Xerox Document Centre 230: Pemasangan Cepat (1 halaman), Ikhtisar Pemindaian (2 halaman), Memulai (48 halaman), Instal Manual (2 halaman)
Halaman Cetak
Installation Requirements:
•
Be sure that the DC220/230/332/340ST is
connected, configured and operational as a
Network Printer with NetWare enabled and
the correct Frame Type selected before
performing this procedure.
•
The DC220/230/332/340ST Scan To File
option kit must be installed before
performing this procedure.
•
Create a user account for the DC220/230/
332/340ST. Use NWADMIN for NetWare
4.x/IntraNetWare, to create an account on
the file server for the DC220/230/332/340ST
with all access rights to the document
Repository except supervisor.
Before Installation:
Please review the DC220/230/332/340ST
Scanning Overview card before proceeding.
For assistance, contact your local Xerox Customer Support Center
602E60410
7KH 'RFXPHQW &RPSDQ\
DC220/230/332/340ST NDS
Record the following information for use during
setup at the DC220/230/332/340ST:
Scan User Name:________________________
Scan User Password:_____________________
NDS Tree:______________________________
NDS Context:___________________________
File Repository Server:____________________
Repository Directory:_____________________
Note: Scan to File requires the typefull (or fully
distinguished) NDS syntax.
Example: cn=xxx.ou=xxx.o=xxx.c=xxx.
1.
Enter System Administrator Setups:
a)
Press the [Access] button on the
Control Panel.
b)
Enter the System Administrator
password by typing
and 22222) on the keypad and
pressing [Enter] on the screen.
Note: #22222 is the factory default
and may be changed by your Xerox
service representative to suit your
needs.
;(52;
Scan to File Quick Install
®
#22222
(# key
Page 1 of 2
2.
Access the Scan to File Setups screens
and assign the Default Repository Server:
a)
On the screen display, press [Scan to
File Setups].
Note: The Job Template Pool and Update All
Templates options on this screen are not used in
this environment.
b)
Press [Default Repository].
c)
Press [Netware].
d)
Press [Server].
e)
Press [Edit] and use the keyboard on
the screen to enter the name of the file
server.
f)
Press [Save].
3.
Assign the Default Repository Path:
a)
Press [Directory Path].
b)
Press [Edit] and use the keyboard on
the screen to enter the path.
Be sure to enter the full path,
including the volume name, to the
DC220/230/332/340ST account
directory.
Example: vol1:\users\scan.
c)
Press [Save].
Over