Xerox Majestik 5765 Panduan Referensi - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Referensi untuk Mesin fotokopi Xerox Majestik 5765. Xerox Majestik 5765 44 halaman. Majestik color series digital color copier / printer
Juga untuk Xerox Majestik 5765: Panduan Tambahan (1 halaman), Panduan Referensi (7 halaman), Panduan Referensi (7 halaman), Panduan Referensi (18 halaman), Spesifikasi (7 halaman)
Halaman Cetak
MAJESTIK 5760/5765 MATERIALS USAGE GUIDE
CAUTION: The use of paper weights greater than 90 lb Index (163
gsm) is likely to result in damage to the copier/printer that will
require a service call. Do not exceed the maximum recommended
paper weights, except where noted (Jupiter Thinplate 7 pt.).
Hints, Tips & Testing Results
Extensive Xerox testing has shown the following:
•
When the recommended materials are run as detailed above,
with the correct tray, mode, orientation and curl, feeding
performance is good, but will not equal 24 lb LX performance.
•
The Heavy-Weight Paper Mode cannot be selected for papers
larger than 8.5 x 11 inches. If heavy-weight papers larger than
8.5 x 11 inches are run, inadequate fusing of the toner will
occur.
•
Image quality on the recommended papers is good, but should
not be expected to equal image quality on 24 lb LX paper. The
rough formation of heavy papers increases the likelihood of
image mottle (light patches) with some images. Mottle is more
likely to occur on images with uniform halftone areas. As
humidity increases, mottle usually increases.
•
A small percentage of sheets may exhibit toner on the lead
edge. Flipping the paper over or manually curling the lead edge
down will minimize this condition.
•
Two-sided copying of heavy-weight papers is not
recommended. Paper curl created when running side 1 can
cause a high jam rate with side 2. If this occurs, flipping the
paper over for side 1 may improve curl and feeding
performance. Manually curling the lead edge of the side 1
imaged sheets down before loading them for side 2 can also
improve side 2 feeding reliability. Image quality on side 2 will
also be reduced with certain images. Light image patches
(mottle) and deletions are likely on side 2, especially in large
halftone areas.
•
Toner saturation on electronic originals should be limited to a
total of 280% (70% for each Color). Higher toner saturation can
result in poorly fused prints.
•
Jupiter Thinplate 7 pt. (181 gsm) has been tested and has
shown improved image quality. Due to its increased weight,
more frequent jams should be expected. It is especially
important to load Jupiter 7 pt. curl down. It may be necessary to
allow the paper to acclimate to the environment before its
natural curl can be determined. Jupiter 7 pt. is distributed by
Kirk Paper Company in the USA (714) 978-1619.
USAGE GUIDELINES
9